Is the 4R70E a good transmission?
The 4R70W is a good transmission, but it has its pros and cons. Let’s look over some of its best qualities, and some of its faults and issues. For one, it has a much better and improved overdrive band. That, and as with any other transmission, you still need to maintain it regularly.
What vehicles have a 4R70E transmission?
4R70E used in: 4.6 L V8 F-150(except F-150 Heritage)…4R70W used in all applications:
- Ford F-Series.
- Ford Crown Victoria.
- Mercury Grand Marquis.
- Lincoln Town Car.
- Ford Mustang.
- Ford Expedition.
- Ford E-Series.
How strong is a Ford AOD transmission?
The bulletproof nature of the Ford AOD transmission can be unraveled just by knowing the right buttons to push. When that has been put in place, you can boost its performance from about 400 hp to as high as 1,200 hp which makes for excellent speed while racing.
How much horsepower can a AOD transmission handle?
450 hp
Because of this odd power flow, Lentech’s Len Bertrand tells us a stock AOD can handle 450 hp, at best, and will always be hard on 3/OD clutch packs.
Will a 4R70W bolt to a 351C?
Bronco Guru. Loc. – A 4R70W or AODE from behind any 5.0 (302) or V6 3.8L Mustang or V6 4.2L F150 will bolt up/work behind any 289/302/5.0/351W/351C/5.8L.
Is the 4R75E a good transmission?
Yes, the 4R75E transmission is outstanding; however, even the best transmissions can experience problems occasionally.
How much HP can a Ford AOD handle?
This unusual system can accommodate up to 450 hp or so before pieces start snapping. A sturdier single-shaft arrangement keeps the converter from locking up in Third and Fourth gears, and this alone makes a worked AOD effective into the 600hp range.
What transmission goes with a 5.0 coyote?
The Coyote can be fitted with numerous manual and automatic transmission options, everything from the venerable C4 three-speed automatic to the latest six-speed manual.
What are the specs of a 4R70W transmission?
The 4R70W transmission requires a three piece closed (needles not exposed) rear case bearing that is approximately .144” thick (See Figure 9). (2) OUTPUT SHAFT RING GEAR – The AOD-E has 72 teeth on the Output Shaft Ring Gear, and the direct drum will not pass through the front side of the ring gear, as shown in Figure 10.
What is the difference between the AOD-E and the 4R70W?
(3) PLANETARY CARRIER ASSEMBLY – The AOD-E has 18 teeth on both the long, and the short pinions, and the thrust plate retaining pins are flush with the retaining plate, as shown in Figure 11. The 4R70W has 25 teeth on the long pinions, 24 teeth on the short pinions, and the thrust plate retaining pins are recessed, as shown in Figure 11.
How many teeth are on a 4R70W sun gear?
The 4R70W has 38 teeth on the Reverse Sun Gear Shell and the outside diameter of the gear is approximately 2.438”, as shown in Figure 12. (5) FORWARD SUN GEAR – The AOD-E has 30 teeth on the sun gear and the outside diameter of the gear is approximately 2.225”, as shown in Figure 13.