How much HP does a water injection kit add?
And how much power can actually be had from water/methanol injection? It all depends on your engine, turbo, the type of gas you use but factor anywhere around 20% horsepower gains on a forced induction engine.
How long does water injection last?
The injections cause a brief but intense stinging sensation, like a wasp sting, that lasts for about 30 seconds and then wears off completely.
What does water injection do for diesels?
Use in diesel Water was injected into the exhaust manifold of a diesel engine and, by opening the exhaust valve during the induction stroke, the injected water and some of the exhaust gas was drawn back into the cylinder. The effect was to reduce NOx emissions by up to 85% but at the cost of increased soot emissions.
How much water do you use to inject methanol?
The most important issue is proper nozzle sizing. It’s far too common that people go off the “if a little is good, more is better” mentality-which is why we recommend a 1:1 ratio of water and methanol.
How long will methanol last?
We use special long life methanol in our door car. If there is 12 litres in the tank it lasts about 7.8 seconds.
Can water damage a diesel engine?
Water causes damage to both fuel tanks and engine parts. Rust and corrosion in the tank create hard particulate that is passed along in the fuel, causing engine wear. Abrasion: Water has lower viscosity than diesel, therefore providing less of a lubricating “cushion” between the opposing surfaces of moving parts.
What percentage of diesel is water?
The aforementioned standard EN 590 allows 200 mg/kg of water content in diesel fuel and indicates coulometric Karl Fischer titration method used for this determination. By using this method we can determine the water content in diesel fuel in the range of 0.003– 0.100% (m/m).
Can I put methyl hydrate in diesel?
It does NOT dry it up, at all, it just mixes it with methanol/ethanol or another alcohol, none of which are a good idea for diesel fuel systems.
Does methanol injection clean valves?
Methanol makes for a very strong cleaning agent and will clear away the gunk that builds up on the valves and keep your engine running healthy and happy. Because it vaporizes at a much lower temperature than water, the meth will pull heat from the intake tract, the piston crown, and the valves.
What is water injection in diesel engines?
Water injection has been around nearly as long as the diesel engine has been in existence. Instead of intercooling, injecting water into a diesel engine can be used to control combustion and exhaust gas temperatures through a phase change.
How does adding water to a diesel engine reduce NOx emissions?
Abstract: Addition of water to the diesel process decreases combustion temperatures and lowers NOx emissions. The most common methods of introducing water are direct injection into the cylinder, a process commercialized in certain marine and stationary diesel engines, and water-in-fuel emulsions.
Why choose Scheid diesel’s water injection kit?
Scheid Diesel’s water kit is a lot simpler than many other units, and it’s also a lot more powerful. Where other pumps will run at 200-300 psi, Scheid’s runs at 400-600 and can be turned up even more if warranted. Before the water injection kit was installed, we needed a place for the nozzle in the intake.
How much pressure does a diesel water injection turbine have?
Since replacing turbos every few runs wasn’t in his maintenance budget, he decided to do something about it. Normal diesel water injection kits run around 200 to 300 psi and are usually marketed with methanol in mind as a power booster.