How do you reattach a pivot rod?

How do you reattach a pivot rod?

Slide the clevis over the stopper rod and insert the horizontal pivot rod into the drainpipe. Tighten the retaining nut just enough to hold the horizontal pivot rod in place. Tighten the clevis screw where you marked it before. Test the stopper rod to ensure all the moving parts are reattached.

What is a sink pivot rod?

In the days before pop-up drains, a rubber stopper was employed when you wanted a sink full of water to rinse out a few things. A sink pivot rod, also known as the ball or horizontal rod, is that part of a pop-up assembly that transfers vertical motion to the stopper when you move the lift rod up or down.

What is a sink lift rod?

The sink’s lift rod controls whether the stopper sits up or down in the drain — once you have installed it correctly. Drop the pop-up stopper into the sink’s drain opening, allowing the stopper to sit in the closed position.

How do you replace a pivot rod in a bathroom sink?

How to Replace a Pivot Rod Under a Sink

1. Look beneath the sink and behind the drain to find the pivot rod.
2. Unscrew the retaining nut that holds the pivot rod inside the drain.
3. Pull the pivot rod out of the drain.
4. Slide the retaining nut and washer off the original pivot rod.

How does a pivot rod work?

The pivot rod is connected to the lift rod by the clevis screw and clevis strap. When the lift rod is pulled up, the clevis strap is pulled up as well, which pulls the pivot rod as well. This pulls the small circle on the stopper down, as well as the stopper itself.

How do you install a new drain Assembly on a sink?

If your new drain assembly comes with a gasket for the topside of the drain that seals it to the sink, slip it up against the drain cup. If you don’t have a gasket, apply a small bead of silicone caulk or plumbers putty to this flange instead. 4. Install The New Drain Assembly

How do you attach a drain strap to a pivot rod?

Connect the vertical strap to the horizontal pivot rod by threading the spring clip on the rod. One end of the clip needs to be on each side of the strap. After the two rods are connected, check to make sure that the pop-up stopper opens and closes fully inside the drain opening.

How do you install a chrome drain ring on a sink?

While holding the drain piece in place, fit the chrome drain ring into the opening from the top of the sink. Thread the chrome drain ring onto the drain tailpiece as far as you can by hand Make sure the pieces are threaded correctly and are not cross-threaded.

How do you remove a pop up drain from a sink?

Loosen and remove the P-trap from the branch drain and sink drain tailpiece, using channel-type pliers. Next, remove the old pop-up assembly, if there is one. Use channel-type pliers or a basin wrench to remove the mounting nut from the tailpiece on the old drain assembly, then lift the assembly clear of the sink.