How high should my CB base antenna be?
Generally, the higher the antenna is above ground, the better it will perform. Good practice is to install your vertical antenna about 5 to 10 feet above the roof line and away from power lines and obstructions. Remember that the FCC limits your antenna height to 60 feet.
How tall is an Antron 99 antenna?
17 feet tall
At just over 17 feet tall, the antenna is large enough to get out a good distance, and small enough for home and small commercial installations.
How high does a beam antenna need to be?
A beam type of antenna at a height of 70 feet or more will provide greatly superior performance over the same antenna at 35 feet, all other factors being equal. A height of 120 feet or even higher will provide even more advantages for long-distance communications.
Do CB antennas need to be vertical?
So, ideally you want a vertical antenna. Pretty much any other shape is going to distort the polarization and result in less signal being picked up by other users. Also, a horizontally polarized antennas at CB frequencies gets to be a bit cumbersome.
Can a CB antenna be too high?
The basic idea behind tuning a CB antenna is to get the SWR to a suitably low reading. If the SWR is too high, not only is the performance of your CB seriously hindered, but you run a very high risk of damaging your radio.
Does an Antron 99 need a ground plane?
This ground-plane kit is made especially for the Antron 99 Base Station Antenna. It lowers the angle of radiation, allowing the antenna to achieve a greater range….Ground-Plane Kit for Antron 99.
| Model / SKU: | GPK-1 |
|---|---|
| Compatible with: | The Antron 99 Base Station CB Antenna |
How high can my antenna be?
In general, the higher you place your antenna, the better. It would be best to have your antenna placed 30 feet above ground level to give you the clearest over-the-air connection with a tower. For those looking for that height, outdoor antennas are usually a good place to start.
What is the minimum height of antenna?
For proper transfer of signal (modulation) the height of the antenna should be comparable to the wavelength of the signal which is to be transferred (at least one-fourth in length).
What causes a high SWR?
The most common cause of a high SWR is an antenna shorted to ground. There are two places a short can occur in a CB antenna system, in the coax and in the antenna stud.
What is the best antenna height for a Freq antenna?
Captain KW has the best answer. The best MINIMUM antenna height is one wavelength above rf ground. In the case of cb freqs, this works out to 36 feet to the base of the antenna. I have always had good success both local and dx using the 36′ height.
What is the range of your A-99 antenna?
Yeah, that’s poor range, My A-99 gets about 122 and beyond miles per foot barefoot, talked to 3 up in New York and one in Canada today barefoot about 15watts if that on sideband that’s over 1600 miles to NY and over 2200 miles to Alberta Canada and my antenna is only at rooftop eve level.
What is the best antenna height for omni directional coverage?
If local rag chew a light weight high as you can install vertical is great for Omni directional coverage. wavrider likes this. Captain KW has the best answer. The best MINIMUM antenna height is one wavelength above rf ground. In the case of cb freqs, this works out to 36 feet to the base of the antenna.
How does the SolarCon Antron A99 fiberglass CB base station antenna work?
The Solarcon Antron A99 Fiberglass CB Base Station Antenna features the Solarcon Twin Ring Adjust-A-Match tuning making it possible to tune the input to the antenna and obtain the optimum S.W.R. over a range of frequencies. Raising the rings raises the frequency and lowering the rings lowers the frequency.