How do I connect my Uniden scanner to my computer?

How do I connect my Uniden scanner to my computer?

1. Go to your start menu and search “Device Manager”
2. Connect the Uniden USB Programming cable to your computer and scanner.
3. Right Click on the “Other Devices” port with your scanners name in it.
4. Select “Browse my computer for driver software”
5. Select the “uniden usbser” folder and click “OK”
6. Click “Next”
7. Click “Install”

How do I download Uniden software?

Downloads

1. Disconnect the power from your AppCam.
2. Download the firmware to your computer.
3. Unzip the file to a folder on your computer.
4. Remove the microSD card from the AppCam.
5. Insert the microSD card into your computer (an adapter may be necessary).
6. Copy the firmware to the root directory of your microSD card.

What is a PC if cable?

Radio Shack PRO-92 The PRO-92 has a mini-jack labeled “PC/IF” (personal computer interface) on the right side of the radio. The unit comes with a “clone” cable that allows the programming from one PRO-92 to be transferred into another.

How do you program a Uniden Bearcat Trunktracker 3?

Press and hold TRUNK for a couple of seconds to enter Trunk Programming mode. Use the number pad to choose a bank number (1, 2, 3, 4, or 5) where you want to store this trunk. Press the trunk button to get out of trunk mode. Then enter the frequencies.

How do I update Uniden home patrol?

Update your HomePatrol-1 Firmware

1. Connect your HomePatrol-1 to your PC using its USB cable.
2. In HomePatrol Sentinel, select “Update Firmware.”
3. Download the new HomePatrol-1 Owner’s Manual by clicking HomePatrol V2 Owner’s Manual.

How do I reset my Uniden scanner?

Reset Uniden Scanner

1. Turn the scanner OFF and unplug the audio cable from the rear of the scanner.
2. Press and hold the L/O and PROG buttons.
3. While holding L/O and PROG, turn the scanner on.
4. Release the L/O and PROG buttons.
5. Press the PD/FD/EMG button THREE times.
6. Press the AIR/MRN button THREE times.