How do I set up my Polycom HDX 7000?

How do I set up my Polycom HDX 7000?

Configuring the Polycom HDX Series

1. Find the IP address of the Poly endpoint.
2. Navigate to the IP address in your browser; you are prompted for a username and password.
3. To edit the H.
4. Use the following settings:
5. Click Update to save all changes, then restart the hardware.
6. To test the configuration, call the H.

How do I adjust my Polycom camera?

During a multipoint call being hosted by a system in the call, you can only adjust a camera at the far site that is currently speaking. 2 Press the arrow buttons on the remote control to move the camera up, down, left, or right. 3 Press Zoom on the remote control to zoom out or in.

How do I enable remote monitoring on my Polycom HDX 7000?

Using the system remote control go to System> Admin Settings>General Settings>Security>Security Settings page 3. Check ‘Allow Video Display on Web.

How do you use a Polycom remote?

To pair the remote control with Polycom Studio: Long press the Remote Control Pairing button on the bottom of the USB video bar until the LEDs blink blue in the middle with a notification sound. Long press Mute on the remote control until you hear a notification sound.

How do I reset my Polycom HDX 7000?

Do a full factory reset by pressing and holding the reset button before turning the power on, and then continuing to hold the reset button for 20 seconds after power on. This procedure completely wipes the configuration and will also set the software back to the factory version installed at the time of manufacture.

How do I enable remote monitoring on my Polycom Group 700?

To enable room and call monitoring: 1 In the local interface, go to Settings > Administration >Security > Remote Access. 2 To allow the room or call to be viewed remotely, enable Allow Video Display on Web.

How do I reset my Polycom remote?

Procedure

1. Unplug the Poly Studio USB video bar to turn it off.
2. Find the reset pinhole on the bottom of the USB video bar.
3. Use a pin or paperclip to press and hold the reset button and plug in the USB video bar at the same time to turn it on. The Poly Studio USB video bar reboots with pulsing amber LED lights.

How do I pair my Polycom remote?

How to Pair the Polycom Studio Remote

1. Turn the Polycom Studio camera bar upside down.
2. Locate the bluetooth pairing button and press the button with your finger until you hear a chime.
3. Long-press the Mute button the remote control until you hear a notification chime.

How do I connect my Polycom to my computer?

Connect Your Polycom Phone

1. Locate the LAN and PC ethernet ports on the bottom of the phone.
2. Connect the ethernet cable for your network into the LAN port.
3. Connect an ethernet cable from your computer or laptop dock/port replicator to PC port, if applicable.
4. Complete the setup process: