Does a MSD Blaster 2 coil need a ballast resistor?
This Blaster Coil is supplied with a ballast resistor. If your application uses a points distributor, the ballast must be used. Late-model electronic ignitions or an MSD Ignition do not require the ballast….Features:
| Brand | MSD |
|---|---|
| Product Type | Coil |
| Secondary Resistance | 4.5K OHMs |
| Spark duration | 350 uS |
| Turns Ratio | 100:1 |
Do MSD ignition coils add horsepower?
Will ignition coils increase horsepower? – Quora. No, unless they’re somehow defective as installed. If you’re asking if aftermarket coils installed in a stock engine will increase horsepower, or reduce emissions, or increase gas mileage, or make the engine run smoother, the answer is no.
Where do I mount my MSD Blaster coil?
It is recommended to mount the PN 8202 and 8223 coils in an upright position. The High Vibration Coil, PN 8222, can be mounted in any position due to its epoxy potting compound.
Can MSD Blaster 2 coil be mounted sideways?
Blaster 2 Coil Mounting?? Mounting any oil filled coil side ways is not recommended. MSD offers a small, Powerful Coil that can be mounted in any direction and is small for tight areas.
Does ignition coil affect performance?
A high performance ignition coil helps engine performance four important ways. First, the higher voltage allows for a larger spark plug gap, which results in a more robust initial flame kernal at the start of combustion.
Are aftermarket ignition coils worth it?
Aftermarket ignition coils are never worth the extra few bucks in savings. In a few cases, you can get away with using a cheap universal aftermarket part as long as it doesn’t affect: The engine’s performance. The vehicle’s safety.
What does a ballast resistor do?
In simple terms, the ballast resistor in a Mopar limits the amperage, or current flow, through the coil while the engine is running, thereby extending the life of the coil and breaker points of the distributor.
Can you mount a contactor sideways?
Design functions the same as a contactor with shunt on one leg. Flexibility to mount sideways as needed to avoid over manipulating wiring.
What are the symptoms of a bad ballast resistor?
Symptoms of a Bad or Failing Ballast Resistor
- Vehicle starts, then immediately dies. The most obvious symptoms will be the vehicle starts, but then immediately dies as soon as you release the key.
- Not starting at all.
- Don’t jump the resistor.
- Let the vehicle be.
How do I know if I have a ballast resistor?
To test your ballast resistor you need an ohm meter or multimeter set to ohms. Remove the connectors from both sides of the resistor. The ohms should read between 1.8 and 5 ohms. You should be getting 9 volts to the positive side of the coil.