Can you use any programming card for any ESC?
Usually the answer is no you can’t. Now some ESCs with different names may or may not be made by the same manufacturere and may or may not be programmed the same.
What is a brushless esc?
Brushless ESC systems basically create three-phase AC power, like a variable frequency drive, to run brushless motors. Brushless motors are popular with radio controlled airplane hobbyists because of their efficiency, power, longevity and light weight in comparison to traditional brushed motors.
What is a brushless ESC?
What is punch setting on ESC?
The punch is basically what others call a current limiter. It limits the amount of initial power that is allowed to go to the motor. Most ESC have this as just a single general setting. Hobbywing gives us much more control over this setting that the competition.
Will a brushless ESC run a brushed motor?
So to answer your question, Can I use brushless ESC with a brushed motor? You cannot use a brushless ESC with a brushed motor.
Where can I learn how to program an ESC?
ESC Programming using the Program Card – YouTube http://www.myrcguides.com/ – Basic Programming instructions for some Hobbywing, Turnigy and Exceed RC ESC’s. http://www.myrcguides.com/ – Basic Programming instructions for some Hobbywing, Turnigy and Exceed RC ESC’s.
Do I need a programming card?
A programming card is a very helpfull tool to have, expecially when you want to be sure that your esc are all with the same settings (you don’t want a esc with the brake ON, do you?). The problem is that usually people realize that they need it when the drone almost ready to fly and no one like to wait weeks to have it!
How many amps does it take to power an ESC?
In the German version is a generalisation from 10 to 120 Amp, thats why I think this could work for every ESC. I tried it with an arduino uno R3. I think it’s also possible with an e.g. arduino Duemilanove or Mega. First you have to connect the ESC to you lipo or NiMH. When you have done that you connect the ESC like so:
Why can’t I connect my ESC to my Arduino?
Because you connected the ESC to your battery, the ESC is put under voltage. Thats why it It is important, that you DON’T connect the red wire to your 5v Port, because it could destroy your computer’s USB Port. On this picture you can see the correct connection between ESC and Arduino (Mega).