How do I use DT9205A?

How do I use DT9205A?

How to Use the Digital Multimeter DT9205A

1. Plug the leads into the appropriate sockets on the DT9205A multimeter.
2. Turn the electrical component’s power on and touch the lead probes to metal contact points on the component.
3. Reverse the position of the leads if you get a negative reading.

What is the symbol for AC current?

11. AC Current. Represented by capital V with a wavy line on top, the symbol stands for current. You should use it when you are measuring AC current.

What is a bad reading for a continuity test?

Seek a replacement fuse or wire if the reading is higher than 10 ohms. If you have a reading higher than 10 ohms, you have poor continuity. The resistance is higher than it should be and you need to replace the wire, fuse, outlet, battery, or device.

What setting do you use to check continuity?

If your multimeter doesn’t have a dedicated continuity test mode, you can still perform a continuity test. Turn the dial to the lowest setting in the resistance mode. Resistance is measured in ohms, indicated by the symbol Ω.

How to use a dt-830b digital multimeter?

– Insert the leads into the proper holes of the hFE socket on the front panel. Digital Multimeter DT-830B Operating instructions AC voltage measurement – Connect the red lead to “VΩmA” jack and the black test lead to the “COM” jack.

How do you test a power supply with a dt830b?

On the DT830b multimeter, place the red probe in the V, W, mA port of the power supply and put the black probe in the COM port. To read the voltage of the DC power supply, you can turn on the digital multimeter and select the appropriate reading mode. You can select either 200m, 2000m, 20, 200 or 1000V.

What is the maximum voltage of dtdt830 series multimeter?

DT830 series multimeter have been designed according to IEC-1010 concerning electronic measuring instruments with a measurement category (CAT 600V), the max. permitted transient voltage: 2500V, and pollution2.

What size fuse do I need for my 830B multimeter?

The correct cartridge fuse is 250 mA. But sadly, most 830B manufacturers use a bigger 1A or 3A cartridge fuses because these are affordable. It’s best that you follow the correct fuse (250 mAh) to prevent damage to the multimeter. Instead of mounting the fuse on the fuse mount, you can solder it instead.