How do you open the top of a Maytag stove?

Warning

Disconnect the power to the Maytag range.
Open the oven the door.
Remove the mounting screws with a ¼-inch socket wrench.
Grasp the top firmly with both hands, one on each side.
Locate the wiring connector located between the top and the rear panel.
Grab the Maytag range top with both hands.

Why is my Maytag stove clicking?

The Cooktop Lock feature helps control the unintended use of the surface burners. If a control knob is turned to Lite when the Cooktop Lock is on, you will hear clicking and you may see the igniter sparking, but the burner will not light. To deactivate the Cooktop Lock: Touch the lock key for 3 seconds.

How do I reset my Maytag stove?

Reset power to the product:

Power unit down by turning off the circuit breaker(s) for one (1) minute.
Power unit up by turning on the circuit breaker(s).
Start a bake cycle.
Monitor the oven for one (1) minute to ensure the error code does not display again.
Verify oven operation.

Where is the model number on a Maytag stove?

You will find the model number on a sticker or rating plate. For cookers and ovens this can usually be found around the frame, behind the door of the appliance. For hobs this can usually be found on the underside, side or back of the appliance.

How do you remove the top of a Maytag stove?

How to remove the old cooktop:

First, open the over door and locate the two screws on the underside of the cooktop that are holding it in place.
Second, use the #2 Philips screwdriver to remove the screws.
Third, lift up the cooktop and gently tug on it, then wiggle it the rest of the way out.

Why does my stove Keep clicking when on?

It could be due to a damaged switch, burner caps that are tilted, dirty igniters, or moisture around the affected part. In some instances, your stove clicks for other reasons other than moisture or food stuck in the ignitor. It may be as simple as the cap is out of alignment or you have broken parts.