Why will my Jacuzzi tub not turn on?

Why will my Jacuzzi tub not turn on?

If your home has experienced a recent power surge or power outage, you may need to head to the breaker box and check to see if the control for your jetted tub is turned to the “off” position. If so, simply turn it back to the “on” position. The fix may be as simple as cleaning or replacing the tub’s filters.

How does a Jacuzzi switch work?

Many hot tubs and spas utilize an air switch to control various functions of the tub. An air switch consists of a pneumatic air button located at spa-side and a pneumatic-activated electrical, air switch located with the spa electronics. The only connection between the two is a small air hose.

Where is the reset button on a Jacuzzi?

You will find a reset button typically on the heater unit. Usually there is a pilot light. When you’re ready to reset, push the button. Some spa units have a high limit switch which will turn off the spa heater if the thermometer fails.

Where is the power switch on a hot tub?

The pressure switch is often located either on a PVC plumbing part next to the spa pack or directly mounted onto the stainless steel heater manifold or tube. The heater manifold can be found either underneath, inside or attached to the power control box.

How do you turn on a Jacuzzi jet?

How to Turn Jets on in the Hot Tub

1. Locate the control panel of the hot tub. This is typically near the hot tub entryway.
2. Turn on the jets. You will see a speed (low, medium, high) that allows you to adjust the force of the hot tub jets.
3. Turn on the timer as well.

How do you turn on an old Jacuzzi tub?

How to Operate a Whirlpool Bathtub

1. Set the water temperature for your bath.
2. Fill the tub with water set to your temperature preference.
3. Climb into the whirlpool bathtub carefully.
4. Press the “On/Off” control on the side of the tub to turn on the pump and start the whirlpool jets.

How do you turn off a Jacuzzi whirlpool?

To toggle the pumps on and off, simply press the jets you would like turned off. That will switch off the therapy pump you indicated. Note: The circulation pump cannot be toggled on and off on the touch screen as it is designed to run at all times to keep the hot tub running effectively.

How do I unlock my Jacuzzi control panel?

Spas using Balboa control systems To unlock the panel, while holding down the “Temperature” button (or the “Up” button if you do not have the “Temperature” button), gently press and release the “Light” button twice.

How do I turn on the jets in my Jacuzzi tub?

Press the “On/Off” control on the side of the tub to turn on the pump and start the whirlpool jets. Wait for up to a minute while the pump primes. Once the pump is primed, the jets will activate.