What is the ETM in a car?

What is the ETM in a car?

Oct 2019 | 0 comments. Unlike the old butterfly mechanical throttle bodies, when all you needed was a screwdriver to adjust the idle, electronically controlled throttle modules started in 1999 for Volvo models S70, V70 AND XC70.

Is there a recall on Volvo airbags?

Published October 21, 2021 Volvo is recalling another 195,000 vehicles in the U.S. because the front driver’s air bags could explode and send shrapnel into the cabin. It’s the company’s third U.S. recall for the issue with air bag inflators made by supplier ZF/TRW.

What is Volvo CEM?

Central Electronic Module (CEM) is the main electrical module on Volvo vehicles that communicate with the rest of your car’s modules and components. When it fails, it can cause unpredictable intermittent electrical problems.

When to know if your Volvo has an ETM problem?

So, if your 1998-2002 Petrol Volvo has rough idle, goes into limp mode, have strange throttle behavior, it should be suffering from the ETM issue. Common ETM – Electronic Throttle Module failure symptoms on 1998 – 2002 Volvo are:

What kind of throttle module does a Volvo have?

Petrol Volvo’s from Aug. 1998 (My99) to 2002 use a “fly-by-wire” throttle module, usually designated as ETM – Electronic Throttle Module that is known to failure due to wear in the internal contacts. So, if your 1998-2002 Petrol Volvo has rough idle, goes into limp mode, have strange throttle behavior, it should be suffering from the ETM issue.

How much did you pay for ETM on your v70t?

Bought a v70t, had all the symptoms of etm. On the air filter housing it had TBA ok and a date painted on it. Wasnt gonna pay the 1600 we paid on my wifes c70 when it went bad, so i visited a local pull-a-part. Paid $35 for a yellow label etm from an s60 (apparently the same as a 5cyl turbo).

Do you need to remove the ETM from a Toyota Corolla?

In any of this cases, you will need to remove and install the ETM from the car. The ETM is located on the lower side of the inlet manifold, but there is NO NEED to remove the manifold. In order to remove the ETM, you should do as follows: