How do you reset the airbag module on a Toyota?
Reset the Airbag Light With a Paperclip (or Something Similar)
- With the ignition turned OFF.
- Remove the Fuse Box panel door located below the steering wheel column.
- You will see a YELLOW connector, reach in and pull it forward toward you.
How do you fix a Toyota airbag light?
How to Reset the Airbag Light on a Toyota
- Find the fuse panel cover under the steering column and open it with your fingers. Pull down on it from the top.
- Look for a yellow electrical connector.
- Take a paperclip and unfold it.
- Put the yellow electrical connector back in place and close the panel cover.
What is a airbag squib circuit?
The squib circuit consists of the center airbag sensor assembly, spiral cable and the steering wheel pad (squib). It causes the airbag to deploy when the airbag deployment conditions are satisfied. Front airbag sensor malfunction.
Why has my airbag warning light come on?
When this light comes on, it indicates that a problem has been detected in the system, and one or more airbags may not inflate in the event of a collision. While it’s possible that all the airbags could work as intended even with an SRS warning light, a failure in the airbags is a significant safety concern.
What does a squib do in a car?
The Clock Spring (aka: Squib) provides electrical connections for various circuits within the steering wheel while allowing the wheel to turn. “The British call it a Squib.
Where is the airbag squib located?
The wiring from the control unit to the Gas generator contained within the airbag is referred to as the Squib Circuit – the signal path is not simply a piece of wire, rather a fairly complex path through various connectors, the clock spring in the steering wheel in case of the driver airbag, and an airbag sensor to …