How do you get a function generator on Multisim?

How do you get a function generator on Multisim?

To place the instrument, click the Function Generator button in the Instruments toolbar and click to place its icon on the workspace. The icon is used to wire the function generator to the circuit. The function generator has three terminals through which waveforms can be applied to a circuit.

Does Multisim have an oscilloscope?

Multisim 14.2 Help It can provide a graph of one or two signals over time, or allow comparison of one waveform to another. To place the instrument, click the Oscilloscope button in the Instruments toolbar and click to place its icon (shown below) on the workspace.

What is a AF generator?

Signal generator is an electronic equipment that provides standard test signals like sine wave, square wave, triangular wave and etc. The signal generator, which produces the periodic signal having a frequency of Audio Frequency (AF) range is called AF signal generator. the range of audio frequencies is 20Hz to 20KHz.

How do you find the current waveform on an oscilloscope Multisim?

Using the Current Clamp

1. Double-click on the Oscilloscope icon to show its front panel.
2. Simulate the circuit and observe the output on the Oscilloscope.
3. Stop or pause the simulation when a trace displays on the Oscilloscope, as shown in the figure below.

Where is the instruments toolbar in Multisim?

Multisim 14.2 Help Instruments are placed on the schematic from the Instruments toolbar. This toolbar displays on the workspace by default. If it is not displayed, select View»Toolbars»Instruments. You can also right-click in any of the blank toolbar areas and select Instruments from the context menu that appears.

Can oscilloscope generate signals?

Most oscilloscopes today have the ability to measure two different input signals (on the same viewing screen) so there are TWO input connectors on the front of the oscilloscope one for CHANNEL 1 and one for CHANNEL 2.