How do you test the PetSafe rechargeable bark control collar?

How do you test the PetSafe rechargeable bark control collar?

How to test your Bark Collar

1. Press and release the power button to power the collar on.
2. Watch for the green light to blink twice, then hold the power button. Continue to hold the power button through the red light.
3. Release the button when the light turns blue to set the collar into test mode.

Why is my PetSafe bark collar not working?

Ensure that the battery is properly installed. Replace the battery. If the Bark Control Collar still does not beep, contact the Customer Care Center at 1-800-732-2677.

What is the button for on the PetSafe collar?

Increase the Static Correction Level by pressing and releasing the Correction Level Button within 5 seconds of the previous flashes. The Static Correction Levels increase from 1 to 5. Pushing the Correction Level Button while the Receiver Collar is on level 5 will cause the Receiver Collar to revert to level 1.

What does flashing red light mean on invisible fence collar?

If you have started to see a red flashing light on your pet’s Computer Collar unit, your Power Cap battery may need to be replaced. If your Invisible Fence control panel is beeping with a lengthy pause between each beep, it’s possible your backup battery unit needs to be replaced.

How do you set a PetSafe rechargeable collar?

Place the collar on your pet so that the PetSafe® logo is right side up and the collar is directly under your dog’s chin. Center the contact points underneath your dog’s neck, touching the skin (B). NOTE: It is sometimes necessary to trim the hair around the contact points to make sure that contact is consistent.

How do I activate PetSafe collar?

To activate the collar, use a coin to turn the Battery Module counter clockwise until the arrow lines up with the “ON” position. If the Petsafe Bark Control Collar is not going to be used on the dog immediately leave it in the “OFF” position.

How long do RFA 67 batteries last?

1-3 months
Keep all of your pet’s essential electronics working their best with PetSafe RFA-67 6 Volt Replacement Batteries. The 2-count pack of 6 volt batteries can provide up to 6 months of power (each battery can last 1-3 months with proper use).

https://www.youtube.com/watch?v=eBNEiRPEU4E