Why does my Toro sprinkler system run twice?

Why does my Toro sprinkler system run twice?

A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time.

How do I reset my Toro sprinkler?

How to Reset a Sprinkler System

1. Turn the control dial to the “off” position.
2. Press the “next” button to access the clear-memory feature.
3. Press and hold the “off” button until the display stops blinking.
4. Turn the control dial to the “run” position.
5. Press and hold down the “minus” arrow and “prog” buttons simultaneously.

Why are my sprinklers not turning off?

It is possible that the sprinkler valves need a good cleaning since dirt and debris can get trapped in the valve and cause problems. So, for a little DIY practice, check to see if the valves are clogged. If the valves are clean, check to see if they are cracked or broken.

Why does my sprinkler keep running?

A common reason why a program is repeating is that you have a second start time set. The start times control the exact time your ESP-Me timer will begin to water and they also control how many times a day your timer will water. The ESP-Me allows you to set up to 6 start times per program.

What causes multiple irrigation zones to work at the same time?

5. Water is coming out of multiple zones at the same time: For the valves to stay open in one zone, while shutting outlets in other zones, there needs to be a minimum amount of water pushed through the valve. To investigate further causes and solutions, go to our FAQ page and look under “Indexing Valves.”

How do you set a Toro sprinkler system?

How to Set the Timer for Toro Sprinkler Systems

1. Turn the program dial to the “Auto/On” setting.
2. Slide the program switch to the zone you wish to program.
3. Turn the Toro Sprinkler timer dial to the “Set Time/Day” position.
4. Turn the dial to the “Set Watering Days” position.

Where is the sprinkler shut off valve located?

Locate the main shutoff valve on your irrigation system. It is between the main water supply to your home and the sprinkler controller. Alternately, the main shutoff is located outdoors near a faucet bib. The main valve may be in a box in this area to protect it from the elements.

Can you connect a Toro rain switch to a relay?

Connecting a Toro Rain Switch (Optional) (Optional) The Toro Rain Switch (model # 53221) is a remote rain Caution: To prevent timer damage, ensure the sensing device which can be connected directly to your relay current draw does not exceed 0.30 Amps.

Is Toro liable for failure of products not manufactured by Toro?

0.35 Amps @ 24 VAC @ 140° F Toro is not liable for failure of products not manufactured by Toro even Maximum Load For Pump/Master Valve: though such products may be sold or used in conjunction with Toro prod- ucts. Government Printing Office, Washington, DC 20402. ference by one or more of the following measures: Stock No. 004-000-00345-4.

How to use ECX 12 12/12/24 hour selector?

12/24 Hour Selector operate your sprinklers. Just set the current time Jumper (4). To store the and day and your ECx will be ready to operate auto- jumper, install it on one pin matically. as shown. See Figure 3.

Where can I find the watering schedule for ECX?

ECx after it is installed. behind the timer. A watering schedule form is provided on page 12 for you Refer to the example form shown on the opposite page to fill out.