What causes F20 error on Whirlpool Duet?
Whirlpool error code F20 appears when no water is detected entering the machine or if the pressure switch trip is not detected. The pressure switch is the part of the machine that monitors high water pressure. The washing machine automatically cancels the wash cycle during an F20 error.
What does F20 mean in a washer?
water inlet problem
F20 indicates a water inlet problem—no water or insufficient water supply.
What does a flow meter do in a washing machine?
The flow meter measures the amount of water going into the dispenser and relays that information to the control board.
What does FH mean on Kenmore washer?
The FH error code indicates that the washer control does not detect water entering the machine within 30 seconds after the fill valves have been opened. It is also displayed after 8 minutes if the flow sensor has detected 10.5 gallons passing through it without the water level pressure switch tripping.
How do I clear f20 code?
To reset the f20 error code, exclude the program crash of the Whirlpool washer. To do this, de-energize your washing machine for 10-20 minutes, then turn it on back. If the error disappears from the display, the problem is successfully eliminated.
How do I troubleshoot a whirlpool duet washer F20 error?
This Whirlpool Duet Washer F20 error troubleshooting and repair information applies to model WFW9200SQ00 and all the models listed under the related models section below. “Unplug the washer and blow into the flow meter and check if it has continuity when you blow through it, if so it’s good if not it’s bad.”
What does F20 mean on a washing machine?
The F20 error code indicates that there is an issue with the machine’s main water supply. There are a few reasons why your washing machine may end up showing this error. Out of all the reasons, the most common is when there is no water dispersed into the water.
Why does my Whirlpool duet washing machine turn off the water?
Whirlpool Duet washing machines allow six minutes before the unit cuts the water supply. The purpose of the pressure switch is to prevent the unit from overflowing. However, in some cases, it can be triggered accidentally.