What can I use to lube my throttle cable?
A silicone spray will do nicely. Avoid general or multipurpose lubricants or any unrelated oils, like motor oil. Do not use chain lube for your cables. Cleaning and lubricating your throttle cables will help the cables last longer while preventing fraying or snapping.
Can you use wd40 on throttle cables?
Some cables have a slick inner sheath that will gum up if exposed to solvents or harsh chemicals, so do NOT use WD-40 or any other type of penetrating oil.
Can you use white lithium grease on cables?
White lithium grease home uses WD-40 High-Performance White Lithium Grease lubricant is also great to apply to home uses such as lubricating: Garden tools. Cables and chains. Water pumps.
Can you use WD-40 on throttle cables?
Can you use chain lube on throttle cable?
Do not use chain lube on cables. For quick work on the cables, nothing beats a pressure cable luber from accessory companies like Motion Pro. Basically, you clamp a rubber stopper over one end of the cable, insert a tube from a can of silicone-based cable lubricant into a little hole, and give the nozzle a squeeze.
Which type of grease is used to lubricate cables?
Wire rope lubricants can be petrolatum, asphaltic, grease, petroleum oils or vegetable oil-based (Figure 3). Petrolatum compounds, with the proper additives, provide excellent corrosion and water resistance. In addition, petrolatum compounds are translucent, allowing the technician to perform visible inspection.
How to lubricate a motorcycle throttle cable?
Take the cable lubricator, insert into the end of the cable and then squirt a few drops into the end of each cable. Reattach the switch housing. Open the throttle all the way. Adjust throttle cable closest to the tank of motorcycle all the way out until the butterfly intake manifold is level (horizontal), rather than straight up.
How do you adjust the throttle cable on a Chevy Silverado?
Take the appropriate wrench and loosen the back screws on the throttle cable adjusters all the way back. Remove the screws of the switch housing and open it up. Take the cable lubricator, insert into the end of the cable and then squirt a few drops into the end of each cable. Reattach the switch housing. Open the throttle all the way.
How to straighten a motorcycle throttle?
Turn the handlebars of the motorcycle until the wheel is straight. Turn the throttle all the way and open and ensure the throttle snaps back. You need to make sure the throttle snaps back in the entire range of motion of the handlebars (if it doesn’t snap back, the throttle may stick during use.)