How do I enable voice VLAN on a Cisco switch?

How do I enable voice VLAN on a Cisco switch?

1. Switch# configure terminal.
2. Switch(config)# interface.
3. Switch(config-if)# trust-device.
4. • vlan-id—Configures the phone to forward. all voice traffic through the specified.
5. Switch(config-if)# end.
6. • show interfaces interface-id switchport.
7. Switch# copy running-config.
8. Switch> enable.

How do you assign a voice to a VLAN?

1. How to Configure Voice VLAN?

1. Create a VLAN on the switch and add interfaces to the VLAN to implement Layer 2 interworking.
2. Configure the OUI to match the source MAC address of the received packet.
3. Configure the voice VLAN function on the interface.

What is the voice VLAN?

The voice VLAN feature enables access ports to carry IP voice traffic from an IP phone. When the switch is connected to a Cisco 7960 IP Phone, the phone sends voice traffic with Layer 3 IP precedence and Layer 2 class of service (CoS) values, which are both set to 5 by default.

How do I add a port to a VLAN?

Assigning Access Ports to VLANs

1. Choose Switch configuration.
2. Choose VLAN Menu…
3. Choose VLAN Port Assignment.
4. Choose Edit.
5. Find the port to assign.
6. Press space on Default VLAN until it shows No.
7. Move over to the column for the VLAN to which this port will be assigned.
8. Press space until it shows Untagged.

How to create a Voice VLAN ID?

Step 1. Log into to the web configuration utility and choose VLAN Management > Voice VLAN > Properties. The Properties page opens: Step 2. In the Voice VLAN ID field, enter a VLAN ID assigned to the Voice VLAN.

How to configure Voice VLAN on the 200/300 series managed switches?

Note: The switch default VLAN (VLAN 1, by default) cannot act as the Voice VLAN. A new VLAN must be created. Refer to the article VLAN Configuration on the 200/300 Series Managed Switches for more information. Step 1. Log into to the web configuration utility and choose VLAN Management > Voice VLAN > Properties.

How do I configure a VLAN on a Cisco switch?

Basic VLAN Configuration Step 1. Login to the switch’s Command Line Interface (CLI). Step 2. (Optional) Enter the following command to display VLAN information: Step 2. (Optional) Enter the show vlan command to see your assigned port. Step 4. (Optional) Enter the show vlan command to see your changes.

How do I add VLANs on the switchport Trunk Mode?

Note: In trunk mode, all VLANs are allowed by default. Using the switchport trunk allowed vlan add command lets you configure the VLANs allowed on the trunk. The following screenshot shows the steps required to set the Gigabit Ethernet port (gi3) as a trunk port and add it to VLAN 200: Step 4.