What size is the torque converter bolt?
1.50 x 15mm
M10-1.50 x 15mm, fits GM TH-350/700/400/200, 4L60, 4L60E,4L80E, 3L80 B78.
How many bolts does a Chevy torque converter have?
There will be 3-4 bolts, which go through the flex plate to the torque converter, which hold the torque converter to the engine flywheel/flex plate.
How tight should torque converter bolts be?
Starts here0:47Fire @ Will : Torque Converter Bolt Torque Specs – YouTubeYouTubeStart of suggested clipEnd of suggested clip25 second suggested clip30 foot pounds is what TPI recommends on other converters. Now once you clamp it to that load youMore30 foot pounds is what TPI recommends on other converters. Now once you clamp it to that load you can insure the converter bolts moves back out.
What size are TH400 torque converter bolts?
Torque Converter/FlexPlate Bolt (Screw),fits GM TH350 TH400#3987930 (3/8″-16x. 570″) TH-350/400. Learn more about free returns.
How do you bolt a flywheel to a torque converter?
Starts here3:21Installing torque converter to flex plate pt1 – YouTubeYouTube
How do you remove a torque converter bolt?
Starts here3:59Locate and remove torque converter to flex plate (flywheel) bolts …YouTube
Should there be a gap between flexplate and torque converter?
Starts here2:54Torque Converter Spacing / Shimming: Tech Tip Tuesday – YouTubeYouTube
How much clearance do you need between flexplate and torque converter?
You should observe 1/8” (. 125”) to 3/16” (. 187”) of air gap between the torque converter mounting pads and flexplate before sliding the converter forward to attach it to the flexplate. If you have 1/8” – 3/16” air gap then you may proceed with sliding the torque converter forward and attaching it to the flexplate.
Are torque converters supposed to spin freely?
As tempting as it is never pull the tranny up with the bolts, it should mate up cleanly with some wiggling, converter should spin freely without touching the flexplate.
Will a powerglide torque converter fit a th350?
Long answer: The input splines on a T-350 and powerglide are different. They are not interchangeable. You can buy input shafts for powerglides to use a T-350 or T-400 convertor, but not to use a gllide convertor in a T-350 or T-400.