How do I connect my D-Link DCS 932L?

How do I connect my D-Link DCS 932L?

Installing a D-LINK DCS-932L Network Camera on your network is an easy 4–step procedure:

1. Assign a local IP address to your network camera.
2. View the network camera using your Internet Explorer web browser.
3. Access the router with your web browser.
4. Open virtual server ports to enable remote image viewing.

How do I connect my Dlink camera to WIFI?

Step 1: Press the WPS button on your camera for 3 seconds. The WPS LED on your camera should start blinking blue. Step 2: Within 60 seconds, press the WPS button of the router that you want to connect.

How do I connect my D Link camera to WiFi without WPS?

How do I connect IP camera without WPS?

1. Place the camera next to your router and connect it to the router with the included network cable.
2. After some seconds a connection LED on the camera switches to green, which indicates that the camera is connected to the network.

Why won’t my Dlink camera connect?

Issue: Step 1: Check the LED on your mydlink camera and ensure that it is GREEN. Step 3: Ensure that any firewalls you may have installed are configured to allow UDP connections. If you are unsure, temporarily disable any firewalls during the setup.

Why is my Dlink camera not connecting to WIFI?

– Both your mobile device and camera have a working Internet connection. If your camera is still not working, please Reset the camera and run the install setup again. To reset the camera, use a paper clip and then press and hold the reset button for 10 seconds and release.

How do I setup my Dlink WiFi extender?

Step 1: Plug the DAP-1520 into a wall outlet within wireless range of your router. Step 2: open the wireless utility on your computer, select the name (SSID) of the DAP-1520 network, and enter the password (both of these are found on the included Wi-Fi Configuration Card).