What is Code B124D?

What is Code B124D?

B124D-02 is Active ( General Signal Failure ) Cannot Clear Code. Checking too see if anyone else has run into this type of problem before and has any Diagnostic Information that they can share as I can see that the TPMS signals are not getting to the proper Communication Module.

Does the body control module control TPMS?

The TPM module is a radio receiver that collects the air pressure data from the Tire Pressure Monitoring System (TPMS) tire pressure sensors. The data is then sent to the Body Control Module (BCM) where a predetermined pass/fail criteria is applied.

At what pressure does the TPMS control unit turn on the low pressure indicator and set a DTC?

28 psi
If it detects less than 28 psi (190 kPa) it alerts the driver by turning on the low pressure indicator and setting a diagnostic trouble code (DTC) in the control unit.

What does TYRE sensors not detected mean?

The “Tire Pressure Sensor Fault” message indicates that there is an issue with the tire pressure monitoring system (TPMS). There is most likely an issue with a tire pressure sensor or the connection to the sensor. It could also be caused by a faulty TPMS control unit, faulty wiring, or a TPMS reset.

Why is tpms light on Honda Odyssey?

If your vehicle’s tire pressure becomes significantly low, the Low Tire Pressure/ TPMS indicator comes on and a message appears on the driver information interface. Tire Pressures Low is displayed when a tire has significantly low pressure. An overheated tire can fail.

What should tire pressure be in Honda Odyssey?

Honda recommends putting 32 psi in the front and 35 psi in the rear tires of your 2019 odyssey.

How do I get the TPMS light to go off Honda Odyssey?

To turn off tpms light on your honda odyssey, press the customize settings option on your steering wheel buttons. Then press tpms calibration, select initialize and then yes before exiting the menu.

How do I fix the TPMS on my Honda Odyssey?

Scroll to the vehicle Settings screen, and select it. Select TPMS Calibration. Select Calibrate….Resetting TPMS in Older Honda Vehicles

1. Press MENU.
2. Select Customize Settings.
3. Select TPMS Calibration.
4. Select Initialize.
5. Select Yes.
6. Press MENU to exit.