How do I access my Netgear NAS drive?

How do I access my Netgear NAS drive?

To access the local admin page:

1. Open a web browser and visit https://. is the name that you assigned to your ReadyNAS system or the default host name if you did not change it.
2. Accept the certificate. A login prompt displays.
3. Enter the login credentials for your system and click the OK button.

How do I connect my Netgear NAS to my laptop?

How do I direct-connect between ReadyNAS and PC/Mac?

1. Assign a static IP address to the ReadyNAS, and set your PC with a static IP in the same subnet.
2. Connect the ReadyNAS and PC NIC using a straight or crossover Ethernet cable.
3. Power on the ReadyNAS and scan with RAIDar to locate the ReadyNAS.

How do I reset my Netgear NAS to factory settings?

How to Factory Reset Netgear ReadyNAS?

1. First of all, turn the ReadyNAS device off and locate the Reset button on it.
2. Take a hold of a paper clip or pin-like device.
3. Press and release the ReadyNAS Reset button using the pin.
4. Now, power up the device and again press the Reset button.
5. Let the lights on your device turn on.

What is Netgear Raidiator?

RAIDar is used to discover NETGEAR Storage devices on your local network. It is currently available for download from the ReadyNAS Downloads. RAIDar 6.3 is independent from RAIDar 4.3. 8, so users will not receive a request to update. The preferred way to find ReadyNAS OS 6 devices is through ReadyCLOUD.

How do I reinstall ReadyNAS OS?

To perform an OS reinstall, continue to hold the Reset button until all Disk LEDs flash once, after about 5 seconds, and then release the button. To perform a factory reset, continue to hold the Reset button until all Disk LEDs flash twice (once at 5 seconds and then 25 seconds later), and then release the button.

What is the default password for Netgear NAS?

The default credentials to log in to the local admin page are: Username: admin. Password: password.

How do I find the IP address of my Netgear NAS?

To find the IP address of your ReadyNAS download and run RAIDar. Access the web admin page of the ReadyNAS by clicking Admin Page in RAIDar or enter the URL https://ReadyNAS_IP_address/admin – where ReadyNAS_IP_address is the IP Address seen in RAIDar.

How do I change the RAID on my Netgear NAS?

In Flex-RAID mode, you assign one of several RAID levels to your volume….To change to RAID levels:

1. If any data is stored on the volumes that you want to reconfigure, back up your data.
2. Delete the volumes that you want to reconfigure.
3. Create a new volume from the available disks and select the RAID level.