Can you use concrete indoors?

Can you use concrete indoors?

It’s not just for sidewalks; concrete is a stylish choice for indoor floors. Its surface can be finished in various ways—with colors, stains, and aggregates—and given a textured surface or buffed until glassy. Concrete floors are extremely durable and easy to clean, and they resist water when properly sealed.

How do you stain concrete indoors?

How to stain interior concrete floors

1. Prepare the surface. Before anything else, you want to make sure you’re working with a clean slate.
2. Clean the surface for optimal results. Once the concrete is smooth and free of any previous coatings, vacuum or wash away dust.
3. Mask the design.
4. Apply the color.
5. Seal the color.

Is polished concrete good for indoors?

Plain concrete slabs have served as the flooring material for basements, garages, patios, and utility areas for many years, but concrete is now also a viable material in home interiors, where it can be polished, etched, or stained to serve as the finished flooring surface.

Is there a difference between indoor and outdoor concrete?

Indoor concrete is generally meant for foot traffic and should provide a smooth look. Indoor concrete is typically polished down to a nice sheen and finished to allow for good grip and a continued shine. Outdoor concrete is often rougher since it is often meant for creating grip for car traffic.

What is a tamped finish?

A tamped finish for unformed surfaces is produced by raising and lowering the compacting beam in its final pass to produce a surface with ridges at a fairly regular spacing of 20 to 30mm and up to 5mm high.

Can you install tile over concrete?

Installing ceramic tile over concrete requires repairing all cracks and voids in the concrete prior to the installation process. Cracks in the concrete eventually will lead to cracks in the tile because the concrete at the point of the crack won’t be able to support the tile. For cracks less than 1/8 inch, use crack suppression products.

How do you finish concrete?

Finishing, Stage One Immediately level and prepare further using a bull float. Use an alternative tool (optional). Tidy the corners using a smaller tool. Cut grooves into your concrete. Wait for the concrete to partially dry. Apply a color hardener (optional).

How to finish concrete?

Spread the concrete. Use a square shovel or a come-along tool to push and pull the wet concrete into place.

Screed the concrete. During this step remove excess concrete and bring the surface of the concrete to proper grade. Use a straight board or special tool called a screed.

Float the surface. Use a darby or bull float to level ridges,fill voids and slightly embed the aggregate. Then allow the bleed water to disappear.

Edge the slab. Once all the bleed water is gone,create neat rounded edges along the perimeter of the slab using an edger.

Groove in joints. Prevent unwanted cracks by jointing the slab with a grooving tool.

Trowel the surface. If you’re looking for a smooth,hard,dense surface,use a steel trowel or fresno for this step.

What is the texture of concrete?

Stamped Concrete. Stamped concrete, commonly referred to as textured or imprinted concrete, is concrete that is designed to resemble brick, slate, flagstone, stone, tile and even wood.