How do I access my Linksys wireless G access point?

To access the web-based utility of the Access Point, launch your web browser. In the Address field, enter the Access Point’s default IP address, 192.168. 1.245, or the IP address you entered during the Setup Wizard.

What is a wireless G access point?

To protect your data and privacy, the Wireless-G access point can encrypt all wireless transmissions. The MAC address filter lets you decide exactly who has access to your wireless network. Configuration is a snap with the Web browser-based configuration utility.

How do I reset my Linksys access point WAP54G?

How to Reset a WAP54G Password

Take a small paperclip and bend one end of it so that it’s straight.
Locate the reset button on the back of the router.
Release the button and wait until the lights stop blinking while the access point resets itself.

How do I setup my Linksys Wireless G?

How to Set Up a Linksys WRT54G Wireless G Router

Step 1: Connect the Modem. Plug the Ethernet cable from your cable or DSL modem into the Internet port on the router.
Step 2: Connect Your Computers.
Step 3: Connect the Power.
Step 1: Log In.
Step 2: Open Wireless Settings.
Step 3: Name the Network.
Step 4: Set Up Security.

How do I setup my Linksys Wireless G router as a repeater?

Click Connectivity.

Click Internet Settings.
Click Edit.
Select Wireless Repeater.
Enter the main router or access point’s Network name (SSID), Network band and Security mode.
Click to save settings. Click Yes to continue.

How do I restore my access point to factory settings?

NOTE: Make sure to press and hold the Reset button properly. The lights on the access point should be blinking while you are holding the Reset button….

Open the access point’s web-based setup page.
Click the Administration tab and then click on the Factory Defaults sub-tab.
Click Restore All Settings.

How do I reboot my access point?

To restart an AP, expand the Access Points section, click the AP’s box on the left side, then click Restart.