How do I find the interface configuration on an HP switch?

How do I find the interface configuration on an HP switch?

You can use the options with the startup config command, show config, and the running config command, show running-config.

How do I configure my HP switch?

How to: Configure a HP ProCurve switch

1. Step 1: Connect your serial connection.
2. Step 2: Conenct PuTTY.
3. Step 3: Get the IP address.
4. Step 4: Set time server.
5. Step 5: Set SNMP community info.
6. Step 6: Launch the web GUI.
7. Step 7: Configure basic info.
8. Step 8: Create VLANs.

How do I access my HP managed switch?

Open a browser software, enter the IP address of your Switch and access the HP Switch web interface. On the prompt screen, enter the administrative login information. After a successful login, the administrative menu will be displayed.

How do I enable Web interface on HP switch?

To enable web login, log in to the device via the console port, and perform the following configuration: • Enable HTTP or HTTPS service • Configure the IP address of the VLAN interface • Configure a username and password The device supports the following web login methods: • HTTP login: • HTTPS login: The following …

How do I configure my HP ProCurve switch to 1800 24G?

HP ProCurve 1800-24G Switch – Installing the Switch

1. Installation precautions.
2. Prepare the installation site.
3. Verify the switch passes self test.
4. Mount the switch.
5. Connect the switch to a power source.
6. Connect the network cables.
7. Installing or Removing mini-GBICs.

How do I setup my HP 2530 24G switch?

Using the console setup screen Connect a terminal device to the switch to display the switch console Command Line Interface (CLI) prompt (The default display). At the prompt, enter the setup command to display the Switch Setup screen. The following illustration shows the Setup screen with the default settings.

How do I turn on https on Aruba switch?

Instructions

1. Connect to the switch via CLI.
2. To enable SSH, enter the following commands: console>enable. console#config.
3. To disable telnet, enter: console(config)#no ip telnet server.
4. To enable HTTPS, enter the following commands” console(config)# console(config)#crypto certificate 1 generate key-generate.

What is the default IP of HP switch?

192.168.2.10
The HP ProCurve Switch 1700 Series has a default IP address of 192.168. 2.10 with a subnet mask of 255.255. 255.0.

How do I configure my HP 1920 switch?

Initial configuration

1. Place the switch close to the PC that will use for configuration.
2. Connect power to the switch, and then start the PC (If it is not already running) and wait until the switch and PC have finished their start-up sequences.
3. Connect the PC to any port on the switch using a standard Ethernet LAN cable.