How do I fix the code on my dishwasher ER?
The Fix: Pressing and holding the cancel button or turning off the power to the dishwasher for five minutes should clear the error code.
How do you reset a Frigidaire dishwasher?
Hold down the cancel button for at least 3 seconds. Find the cancel button on the far-right side of the control panel. To reset the dishwasher, hold this button down for 3 seconds or until the light display disappears or changes.
What does P mean on Frigidaire dishwasher?
Common Frigidaire Dishwasher Problems When there is a power failure the dishwasher will display the PF error code. This fault code means that the cycle has been delayed until the hot water supplied to the dishwasher reaches operating temperature.
How do you run diagnostics on a Frigidaire dishwasher?
Press and hold Start/Cancel and heating option for 3 seconds to turn on water test mode on your dishwasher. Press Start/Cancel if you want to advance through the test. Error code will be displayed if the component fails.
Do Frigidaire dishwashers have a reset button?
To reset the Frigidaire dishwasher, you must hold down the cancel button for at least 3 seconds. This will not only shut off the dishwasher but also reset it as well. After waiting for at least five minutes, restart the dishwasher and load it with dishes.
How do I fix the ER code on my Frigidaire dishwasher?
Frigidaire Dishwasher Error Code = ER Check / Repair / Solution = Main Control Board has detected a stuck key or a key pressed for more than one minute. Check connection from keypad to Main Control Board. If correct, replace keypad. If error still exist, replace Main Control Board.
What would cause a Frigidaire dishwasher not to drain?
Sometimes, a Frigidaire dishwasher not draining water is due to an air gap or garbage disposal clog and not a dishwasher issue. Water will then backflow into the dishwasher during a wash cycle. Running the disposal before starting a wash cycle can clear the drain of debris that can block water flow.
Why is my Frigidaire dishwasher flashing Ho?
Non-Error Codes “HO” means the water isn’t warm enough, and the dishwasher is waiting for it to heat before proceeding to wash dishes. You can run the faucet prior to starting a new cycle to ensure water is hot enough. Finally, “LO” means the dispenser is low on rinse aid solution, and needs to be refilled.