How do I reset my APC Smart UPS 2200?

How do I reset my APC Smart UPS 2200?

APC Smart UPS – How to reset / restart

1. Turn off and unplug UPS from wall.
2. Press and hold the OFF button again.
3. You may see a quick flash of the LED’s and you should hear an audible “”click”” from the UPS.
4. Turn UPS back on.

How do I reset my APC?

Locate the APC network management interface on the back of your APC UPS. Press the reset button for 20 seconds. Wait for the network led change to the orange color. The APC UPS network management interface will reset its configuration back to the factory default.

How do you hard reset a UPS?

The Brain Dead procedure performs a hard reset of the Smart-Ups microprocessor….Cold Start:

1. Turn off and unplug the Smart-UPS from wall.
2. Press and hold the power button (labeled “”I/TEST”” on legacy non-LCD screen units) on the front of the UPS until you hear a LONG beep.
3. Let go DURING the long beep.

How do you reboot a UPS?

Turn off the UPS: press and hold the On/Off button until the UPS beeps, then release the button. Disconnect the UPS from the AC outlet. 3. Reconnect the UPS to a functioning AC outlet.

How do I restart APC UPS?

Tutorial APC UPS – Restart the management interface only Open your browser and enter the IP address of the APC UPS. After a successful login, you will be sent to the APC UPS Dashboard. Select the Reboot Management Interface and click on the Apply button. In our example, the Network Management Interface will restart.

How do I reset my luminous UPS?

When the inverters get tripped press the inverter reset button available in your device to readjust the inverters. If the batteries are dead or if they become weak it is greatly advisable to switch off the batteries for a short period of time.

How do I fix UPS overload?

Disconnect nonessential load equipment from the UPS to eliminate the overload. If the overload is severe, the input circuit breaker may trip (the resettable center plunger of the circuit breaker pops out). Disconnect nonessential load equipment from the UPS to eliminate the overload and press the plunger back in.