How do I reset my Jaguar handbrake?

How do I reset my Jaguar handbrake?

k44ent

1. Reset the EPB module as detailed below. a.
2. Start the engine.
3. Firmly apply and release the footbrake five times.
4. Confirm that the message ‘NOT CALIBRATED’ or ‘APPLY FOOT.
5. Lightly press the footbrake pedal.
6. Apply the parking brake by using the EPB switch.
7. Release the parking brake.
8. Release the footbrake.

How do I reset my electric parking brake?

Here’s how to reset it;

1. Switch the ignition to the ON position and shift the gear lever in PARK.
2. Pull and release the EPB button to activate the electric parking brake.
3. Pull and hold the EPB button until you hear a mechanical sound, then release the button.

How do you disengage an electric parking brake manually?

With the AUTO switch OFF, the EPB can be applied by pushing and holding the parking brake switch. This will work with the ignition switch ON or OFF and with the vehicle moving or stationary. To release the brake, pull and hold the manual switch while at the same time pressing the brake pedal.

What does parking brake fault mean?

Electric Parking Brake Module Failure If your parking brake is making a screeching sound and the parking sensor light is flashing, this is usually a sign that your Electric Parking Brake Module has failed. If you try to drive your vehicle under this circumstance, it can cause damage to the braking system.

How do you unscrew a parking brake?

If your car has a pull handle, pull it toward you until you hear and feel the brake release. If your car has a push-pedal system, push down and release the pedal. You should feel the brake release.

How do you reset the handbrake on a Jaguar XF?

If the battery has been discharged or disconnected, Apply Foot And Park Brake will be displayed in the Message centre when the ignition is next switched on. Press the brake pedal and pull the EPB switch up to apply the EPB. This is required to reset the EPB system. The EPB will now function correctly.

Can you drive with parking brake malfunction?

The various uses and frequency of the parking or emergency brakes vary from person to vehicle. However, despite the variances, a broken parking brake is not something to take lightly. In fact, driving with a faulty e-brake for an extended period of time can cause undue damage to your transmission.

What is parking brake fault?

Does electric parking brake drain battery?

Registered. It’s just an electrically operated parking brake. It doesn’t need electricity to stay on or off.

Where is the parking brake on a Jaguar?

Jaguar Owner Information. The parking brakes operate on the rear wheels. Therefore, secure parking of the vehicle is dependent on being on a hard and stable surface. The switch which operates the EPB is mounted on the centre console, to the rear of the gear selector.

How to recalibrate the handbrake?

To recalibrate it disconnect your battery and leave for 10 Min’s. then reconnect and with the ignition on apply the foot brake and whilst keeping applied switch the parking brake on. then release the foot brake turn ignition off – on and the handbrake fault message should be gone and the parking brake should release as you drive off.

Why is my handbrake light on but not working?

The most basic check for this is – is your battery up to 100% efficiency. the handbrake module is notorious for faults with low voltage or voltage dips. Next is to check that the brake pads and cables are free and in good condition (pads not worn too far down) as these can cause fault indications.

What does it mean when your car says parking brake fault?

Do you mean ‘parking brake fault’ This message can sometimes appear with low battery causing the electronic park brake to lose its calibration.

What are the problems with the 2004 Jaguar Diesel S type 2004?

Jaguar diesel S Type 2004 If parking brake is released but system warning still sounds. The problem is the sensor still think it’s on need to unplug sensor. I had same problem with my car.