How do I reset my Worcester boiler Greenstar 30si?

How do I reset my Worcester boiler Greenstar 30si?

In most cases, you will simply need to hold the button marked ‘reset’ for three seconds. In some models you may see a reset light at the end of the temperature dial. In this case, just turn the dial down to the reset light, leave it there for three seconds and then turn it back to its original position.

How do I adjust the water temperature on my Worcester boiler?

Starts here1:08Setting your temperatures on the Worcester-Bosch Style combi boilerYouTubeStart of suggested clipEnd of suggested clip58 second suggested clipAnd the boiler I just shows what it’s set up so if you want to say a hot water you press a hot tapMoreAnd the boiler I just shows what it’s set up so if you want to say a hot water you press a hot tap there. And use these two arrows here to adjust that.

How do you reset the water pressure on a Worcester boiler?

External Filling Loop

1. Attach the hose to each side of the valve and open the mains cold tap.
2. Open the second tap which allows water in to the heating system.
3. Watch the pressure rise and stop once the bar reaches just about one and turn off both taps.

How do you add pressure to a Worcester boiler?

Starts here2:31How to re-pressurise your Worcester Bosch Boiler – YouTubeYouTubeStart of suggested clipEnd of suggested clip53 second suggested clipAnd right just to the right of that there is a little hole. Here this key goes up there give it aMoreAnd right just to the right of that there is a little hole. Here this key goes up there give it a good push. Until the point of this arrow is almost in line with the black plastic.

Why do pilot lights go out on boilers?

Thermocouple Malfunction It is positioned very close to the flame, and when lit, the pilot light tells the thermocouple to keep the gas line open. A thermocouple that is dirty or malfunctioning will often shut off your gas supply in error, causing the pilot light to go out and your furnace to stop working.

How do I turn up the water temperature on my boiler?

How to Adjust the Water Temperature of a Hot Water Boiler

1. Test your tap water temperature. Allow the water to run until it is fully hot and fill up a tall glass.
2. Adjust the thermostat.
3. Turn the knob on the side of the tank.
4. Rotate the thermostat control.

How do I increase the pressure on my Worcester Greenstar 30si?

Starts here3:30How to Repressurise a Heating System with an Internal Filling KeyYouTube