How do I set my Hunter programmable thermostat?

How do I set my Hunter programmable thermostat?

Hold down one of the UP/DOWN arrow keys until the display flashes. Use the arrow keys to move the temperature setting to the desired temperature. Press the HOLD/RETURN button. The thermostat will now hold the temperature at the setting until the override is cancelled.

Are hunter thermostats any good?

4.0 out of 5 stars Great thermostat for a great price. This is our 2nd Hunter Thermostat as we just moved and I didn’t bother uninstalling from the old place because they’re so inexpensive. We only use it for heating so install was super simple if you pay attention to your wiring.

What is SPAN mode on Hunter thermostat?

Span. The span setting regulates when and how long your system will run. The span has been set at the factory to 0.5º (in Fahrenheit mode) which will allow the system to turn on 1ºF above or below the set temperature and run for 1ºF above or below the set temperature.

What is the color code for wiring a thermostat?

yellow
This is the most typical thermostat wiring style, and it applies to systems that regulate both heat and air conditioning. The wires are typically arranged as follows: red for 24-volt hot, white for heat, yellow for cooling, green for the fan, and blue for common (although the common wire may be a different color).

How do I cancel my hunter thermostat?

How to Delete Programming on a Hunter Thermostat

1. Open the faceplate on the Hunter thermostat.
2. Twist a paper clip so one of the ends is sticking out.
3. Press the end of the paper clip into the “Reset” pinhole and hold it for two seconds to clear the programming.

What is the set point on a thermostat?

A setpoint is “the [temperature] point at which a thermostat has been set”. Straightforward, right? Many thermostats have 2 setpoints, a heating setpoint a and cooling setpoint.

Are there any user manuals for the Hunter 44860 thermostat?

User Manuals, Guides and Specifications for your Hunter 44860 Thermostat. Database contains 3 Hunter 44860 Manuals (available for free online viewing or downloading in PDF): Manual del propietario, Installation and operation manual .

How do I replace the wall plate on my Hunter thermostat?

Position the new wall plate on the wall horizontally and pull the labeled wires through the opening. 3. If the existing holes do not match those on the Hunter thermostat wall plate or, if there are no existing holes, visually level the wall plate and mark the wall for two holes. Page 16 Terminal Shield Terminal Screw Jumper Wire 44002-01 R111809…

How do you uninstall a thermostat without damaging it?

UNINSTALLING THE EXISTING UNIT 1. Turn the system power OFF at the existing thermostat. Turn the power to the HVAC system OFF at the main power panel or at the furnace. (Failure to turn off the power to the existing thermostat before removal could damage your system.)

How do you put a battery in a thermostat?

Page 21 ATTACHING THE THERMOSTAT 1. Insert three AA alkaline batteries into the back of the thermostat. 2. Place the thermostat over the wall plate, aligning it over the terminal and battery openings. Press the thermostat to the wall plate and it will snap into place.