How do you do the fishtail swag?

How do you do the fishtail swag?

Lay your pressed fishtail swag on a flat work surface with the lining side up. Then fold accordion style. Each fold should be about 4 inches wide (as shown). You should end up with the patterned side down on the bottom fold and the patterned side up on the top fold.

How do you make a swag curtain?

Start by hanging one end of the swag over one end of the rod. Then, hang the other end of the swag over the other end of the rod. Let the fabric in the middle drape down. When you’re finished, the draped fabric in the center should look like a regular curtain swag.

How do you calculate fabric for swags and tails?

Swags – Based on an average of 44″ per swag, you will need 2 yards of fabric per swag. Jabots – Double the longest length, add 4″ and divide by 36. This will give you the number of yards needed for a single pair of Jabots.

How do you measure fabric for swag curtains?

Use a metal tape measure to calculate the distance from the horizontal cord to the deepest part of the swagged cord — use this as the swag depth measurement. The width of the swag is the measurement from the left to the right pin. Repeat across the window for multiple swags.

How do you wrap curtains around a rod?

Wrapping Around Curtain Rod

1. Lay the sheer out straight and fold it in half.
2. Place the center of the sheer on the center of the curtain rod and attach with a large binder clip or a piece of masking tape.
3. Wrap the sheer over the curtain rod several times on each side of the binder clip.

How do you hang a swag curtain without a rod?

5 Creative Ways to Hang Curtains Without Rods

1. upholstery tacks.
2. tension cables.
3. hook-eye screws and drapery pins.
4. staples and furring strips.
5. cabinet knobs.

How long is a jabot?

It should be a trapezoid 4 inches on top, 6.5 inches tall, with a 6 inch base. You can change these measurements based on how large you want to make your jabot but this is a good place to start.

How do you calculate fabric for a valance?

Divide the cut fabric width by the width of the chosen fabric for the number of widths required. Multiply that number by the cut fabric length. Divide the result by 36 for the number of yards of fabric required for a self-lined gathered valance.