How do you hang romal reins?
When you’re not using your romals, disconnect them from your bridle, and hang them by the connector between the reins and the romal. This allows both pieces to hang straight so they don’t kink or bend. Be sure to keep them out of sunlight to prevent discoloration and heat damage.
How long are romal reins?
Romel reins generally come in six foot lengths. They come in a variety of natural bridle colors.
What is the purpose of Romel reins?
Romal reins allow for minimal movement of the rider’s hand and create more precise, light cues to the horse through the bit. Christian explains, “There’s a lot of tradition behind using romal reins. When you use them, it shows the quality of your horse and the quality of the rider.”
How do you hold Rommel reins?
How to Hold Romal Reins
- The romal should go across the palm and around the thumb.
- The hand should be closed into a fist over both reins with no fingers in between, and the thumb must be on top.
- The rein hand should always be in front of the romal’s knot, where the two reins meet.
What are Rommel reins?
Romal reins are an extension of braided material attached to closed reins and can be found in many western events from reining, working cow horse and ranch riding to western pleasure and trail. Trainer Jay McLaughlin regularly uses romal reins with his reining and reined cow horses.
What is a Romel?
A Romal (pronounced ro-MAHL), is a type of long quirt attached to the end of a set of closed reins that are connected to the bridle of a horse. It is not to be used to strike a horse, but rather was a tool used to assist in moving cattle.
Are Romel reins good for trail riding?
Some riders use a romal in trail and other all-around events, but the romal is useful for a variety of disciplines. Metcalf says they’re also helpful for training a horse. They are helpful for keeping your horse upright and between your reins.
What are romal reins?
What is a Rommel rein?
Romal Reins are used on horses that have transitioned to a shanked bit or spade bit after being well trained in a hackamore and/or snaffle. The romal is larger in diameter and heavier than each rein and has braided buttons on the lower end to give it balance.
What is the difference between a romal and reins?
The reins are attached to the bit with rawhide or leather loops, snaps, or rein chains. They make up approximately half the length of the entire piece of equipment. The romal is a single cord equal in length to the reins and joined to them with a connection strap. A popper, that can serve as a quirt, is attached at the end of the romal.
How do the reins attach to the bit?
The reins attach to the bit with rawhide or leather loops, steel snaps or rein chains. Rein chains add extra weight to the bit end of the reins to help horses develop a good headset.
What is a romal and how is it used?
The horse feels the buttons and responds better than with plain leather reins. At the end of the romal a popper or quirt is attached. This was used by the vaqueros to both train the horse and aid in moving cattle. It’s constructed of a flat doubled piece of leather so it makes a pop when it touches a surface.
What are the best reins for a hackamore?
Romal Reins are used on horses that have transitioned to a shanked bit or spade bit after being well trained in a hackamore and/or snaffle.