How do you make throw pillows without pointy corners?

How do you make throw pillows without pointy corners?

Seam-Trimming Method This is especially true when you are using heavy upholstery fabric. The simplest solution is to trim the seam allowance diagonally at the corners and the seam allowance as it approaches the corner before you add a seam finish. In some cases, this simple solution will eliminate the pointy corners.

How much fabric do I need for a round pillow?

The fabric should be 1 to 2 inches (2.5 to 5.1 cm) larger than what you want your pillow to be. This will give you room for seam allowances and cutting. The “right side” is the front or patterned side of a piece of fabric. The “wrong side” is the back or blank side of a piece of fabric.

How to make homemade pillows?

Choose your fabric. Almost any fabric can work,but consider the purpose of the pillow you want.

Cut the fabric into two squares or rectangles of equal size. Add ½ inch (1.27 centimeters) to each side to allow for seam allowances.

Place the two fabric pieces together right-side-in.

Sew three of the edges together.

Turn the pillow right-side-out.

How to sew a 20×20 pillow cover?

Cut two pieces of fabric the same size of your pillow form. For a 20” pillow form,cut two 20” x 20” squares of fabric.

Place fabric squares on top of each other with the right sides together. Make sure the pattern is going the same direction,if necessary.

Place clips or pins on the fabric to mark ½” from each side of the zipper.

Use a zig zag sitch or straight stitch to sew across the zipper ½” from the end several times.

Sew from each bottom corner to the clip or pin with a ¼” seam allowance. Back stitch at beginning and end.

Press open the entire length of the seams with an iron. For the part not sewn,fold under 1/4 inch and press flat.

Lay zipper face down in the center on top of the seam. Pin it in place.

Use a zipper foot to sew along right side of zipper. Just before reaching the zipper pull,lift the presser foot and move the pull past the foot.

Open the zipper at least half way. Fold the pillow cover in half again with the zipper along the bottom.

Sew seams with a ½” seam allowance. Start on one side,then sew across the top and down the other side.

Clip off the corners of the fabric with scissors in order to reduce the bulkiness when you turn the pillow cover inside out.

Turn the pillow cover right side out. You might want to use a chopstick or turning tool to poke out the corners to be straight,if necessary.

How do you cover a round pillow?

Sew 1 fabric-covered button onto the back of the pillow to cover the hole. Thread a long needle with strong thread. Push it through the front of your pillow and out the back, leaving an 8 in (20 cm) tail. Thread the needle through your first button, then push it back through the pillow.

How to make a throw pillow?

Cut Fabric

Trim! (optional)

Pin Your Seams!

SEW

Stuff Your Pillow!

Finish Sewing

THROW! Your Pillow!