How do you remove the drain plug from an old bathtub?
Set the drain to its open position. Unscrew the knob on the top of the drain stopper to see if there is a set-screw underneath. If your drain stopper has a set-screw, use a small screwdriver or a hex key to unscrew it. Twist the entire stopper counterclockwise until it pulls free from its mounting post.
How does a clawfoot tub drain?
Source and drain lines come through the floor. In a typical clawfoot tub installation, both the water source pipes and the drain pipe enter the bathroom through the floor. Consult with a licensed plumber if you intend to install a clawfoot tub on the second floor of your home!
How do you use a toe-touch tub stopper?
Toe-touch stoppers can be pushed in place to block the drain of your tub. To release, you simply push them again, and they pop back up. The most important part of this type of stopper is the rubber seal, which holds the water in the tub. The seal can wear out over time, but can be easily replaced.
What do you do with old clawfoot tubs?
The tub can be used as a planter, outdoor furniture, indoor furniture and many other transformations.
- Turn it into a planter in your garden.
- Transform it into an outdoor sofa.
- Transform it into a chaise lounge.
- Turn it into a couch.
- Upcycle it into a chair.
- Transform it into a coffee table and planter.
How many gallons does a clawfoot tub hold?
Clawfoot tubs can hold between 40 to 60 gallons of water.
How do you make a bathtub stopper?
Place the cloth or sponge inside a plastic sandwich bag. Squeeze as much air out as you can and zip it closed or use a rubber band to secure it. Stuff the bag into the drain. The material should expand to snugly fill the hole, and the plastic bag will prevent water from escaping down the drain.
Why does my tub not hold water?
If your bathtub doesn’t hold water, the culprit might be a faulty bathtub drain stopper. It also drains the tub when not in use. In most cases, an issue with the bathtub drain stopper is usually because it has disconnected from the spring or plug that connects it to the linkage.
How do you replace a tub drain plug?
Insert the removal tool into the drain body, also known as the flange. When you are using the dumbbell type of removal tool, seat it properly in the drain by ensuring the notches on the end of the dumbbell fit between the crossbars in the drain. Choose the end that fits into the drain crossbars the tightest.
How to replace a bathtub drain?
Choose Your Tools. Items needed to remove and replace a modern screw in bath tub drain (not all drains are like this).
How do you clear a blocked bathtub drain?
Put enough water in the bathtub or sink to cover the bottom of the plunger, block the overflow outlet with a rag, put the plunger over the drain, and push down and up five or six times. The pressure should clear any clog and open up the pipe. Lift up the plunger and the water should quickly drain away.
How do I remove my tub drain stopper for cleaning?
Remove the knob on the top of the stopper. Hold the body of the stopper in place with one hand and with the other hand unscrew the knob by turning it counter-clockwise. If the knob will not unscrew, then wrap the rag around the knob and use the pliers to help remove the knob.