How do you turn off the tire pressure light on a BMW 328i?

How do you turn off the tire pressure light on a BMW 328i?

With Turn Signal Lever

1. Stop the vehicle.
2. Adjust the cold tire pressure in all four tires recommended on the tire placard.
3. Starting the engine.
4. Go to the TIRE PRESSURE menu by using the ▲or▼ button.
5. Press the BC button once.
6. Hold down the BC button again for 5 seconds.
7. Drive the car.

Why does my BMW keep saying low tire?

What does it mean: The BMW tire pressure monitoring system (TPMS) is designed to alert you when tire pressure is too low in your vehicle. The warning light illuminates when air pressure is 25% below the normal recommended pressure for your BMW model. Make sure the tires are properly inflated to the correct pressure.

How long does it take to reset TPM BMW 328i?

Start the car and let it run for 20 minutes to reset the sensor.

What is the tire pressure for BMW 328i?

32 PSI
The recommended tire pressure for most BMW models is 32 PSI (pounds per square inch), but you should always check the specifics for your vehicle. You can check the sticker on the inside edge of the driver side door, or consult your owners manual.

How do you reset low tire pressure on a BMW?

From the home menu click car, vehicle status, tire pressure monitor, and tire settings. With the car stopped, and the engine running select perform reset. You will need to go on a short drive for the reset to be completed.

What does the TPMS light mean on a BMW?

If the TPM or TPMS light flashes, it means there is a malfunction with the tire monitoring system. A BMW Tire Pressure Monitoring System detects a 20% loss in tire pressure, and it triggers a TPM warning to alert the driver.

How to reset tire pressure on BMW 320i 328i 330i 335i 320d 325d 335d?

In this BMW 320i 328i 330i 335i 320d 325d 335d, you can reset tire pressure via the menu on iDrive. Here’s how to do it: Just like the previous generation, you can access the tire pressure menu to reset the TPM via Drive on the 318i 320i 330i M340i 316d 318d model. Here’s how to do it: The TPM calibration process will complete during driving.

How does the tire pressure monitoring system work on a BMW?

A BMW Tire Pressure Monitoring System detects a 20% loss in tire pressure, and it triggers a TPM warning to alert the driver. On a BMW, this system may also be called Flat Tire Monitor or FTM. If the tire pressure is correct, you may be getting a TPM malfunction or inactive errors because: TPMS sensor is defective

How do I Turn Off the tire pressure light?

Here is how to turn it off. It is a simple reset you should do when get a light from changing tires or updating tire pressures. 1. Turn key to position 2 (car not running) 2. Press and hold Tire Pressure button 3. Wait until light turns yellow 4. Release button and take it for a drive. 5. You’re done.