How do you wire a Honeywell 6160 keypad?

How do you wire a Honeywell 6160 keypad?

Run the black wire from the (-) terminal on the keypad to the Aux Pwr (GND) terminal on the control panel. Run the red wire from the (++) terminal on the keypad to the Aux Pwr terminal on the control panel. Run the yellow wire from the Y terminal on the keypad to the “data out” terminal on the control panel.

Can you use Ademco key fob with 6160 Alpha keypad?

The ADEMCO 6150 and ADEMCO 6160 are addressable Remote Keypads designed for use with ADEMCO control panels. The keys on the keypads are continuously backlit for convenience.

How do you replace a Honeywell 6150 keypad?

I have 17yo Ademco system. Keypad worn out needing replacement. The system is Vista 20P/15P and the keypad is 6647 which is not on the market no more. It is a 4 wire keypad.

How do you wire a Honeywell alarm keypad?

At the keypad you will wire the red into the ‘+’ terminal, the black into the ‘-‘ terminal, the green into the ‘G’ terminal, and the yellow into the ‘Y’ terminal. At the panel end you’ll wire the black into terminal ‘4’, the red into terminal ‘5’, the green into terminal ‘6’, and the yellow into terminal ‘7’.

How do you change a Honeywell keypad?

How to change the master code of a Honeywell Alarm system

1. Press 8 (the CODE key).
2. Press 02.
3. Enter a new four-digit master code.
4. Re-enter the new code. The keypad will beep once to let you know that the code has been changed.

How do I mount and wire the 6160rf keypad?

The 6160RF has terminal blocks for connection to power and data wires. Removing the keypad’s case back provides access to the terminal blocks. The 6160RF can be surface mounted directly to walls, or to a single- or double-gang electrical box. Follow these steps to mount and wire the keypad: 1.

How far should the 6160rf be from the control panel?

The 6160RF must be at least 10 ft from the control panel to ensure proper operation of the RF receiver. the opening in the case back. (see the control panel’s instructions for proper run lengths.)

How do I mount and wire the keypad?

Follow these steps to mount and wire the keypad: 1. Push the two case release snaps at the bottom of the keypad with the blade of a medium screwdriver (this will push in the release snap), then pull that side of the case back away.

How do I connect my 6160rf to my TV?

Pass the wiring from the control panel through INSTALLING THE 6160RF Locate the 6160RF in an area and at a height where it is convenient for user operation. The 6160RF must be at least 10 ft from the control panel to ensure proper operation of the RF receiver.