How much power can a NAG1 handle?
In it the article said that the max torque for the NAG1 is 428 ft-lbs. If this is so, how does the SRT-8 use this trans.
Are all NAG1 transmission the same?
No, not all NAG1 transmissions are the same. There are a few differences, as some are 6.1 NAG1 transmissions and others are 5.7 NAG1 transmissions.
Is the NAG1 a good transmission?
The NAG1 is a beast. Very stout transmission that can also shift very quickly. Lots of people have 600+ hp cars with a stock NAG1 and they have absolutely no problems. The gear ratios in the transmission itself are also very good and well spread out.
What does NAG1 stand for?
The acronym NAG1 denotes “New” for N, “Automatic” for A, “Gearbox” for G, and “generation 1” for 1. Also, this 5-speed transmission is used to denote a category of automatic transmissions that have a round 13-way connector. The connector is stationed near the right side, front corner of the transmission oil pad.
How can you tell if a transmission is NAG1?
The transmission can be generically identified visually by the presence of a round 13-way connector located near the front corner of the transmission oil pan, on the right side. Specific transmission information can be found stamped into a pad on the left side of the transmission, above the oil pan rail.
What transmission is in a 2009 Charger?
4 & 5-speed automatic
2009 Dodge Charger/Transmission
How many speeds is a NAG1 transmission?
5-speed
The NAG1 automatic transmission is an electronically controlled 5-speed transmission with a lock-up clutch in the torque converter. The ratios for the gear stages are obtained by 3 planetary gear sets.
How much transmission fluid does a NAG1 transmission hold?
Registered. For the NAG1 (W5A580) 5-speed transmission a standard fluid/filter change will take 7.4 quarts of ATF +4 Automatic Transmission Fluid. Then check the fluid level, based on temperature, to see if any additional fluid is needed.
How can you tell if a transmission is nag1?
How much horsepower does a 2009 Dodge Charger SRT8 have?
425 hp
2009 Dodge Charger SRT8/Horsepower
What vehicles have a W5A580 transmission?
Later, it was used in the Jeep Liberty, Grand Cherokee, Dodge Charger, Dodge Challenger, and Ram truck, as well as every automatic-transmission SRT8 through at least 2012, and the 2012 Jeep Wrangler.
What kind of transmission fluid does a NAG1 take?
How does the NAG1 electronic transmission work?
The NAG1 electronic transmission has a fully adaptive control system. The system performs its functions based on continuous real-time sensor feedback information. In addition the TCM receives information from the PCM (engine management) and ABS (chassis systems) controllers over the CAN bus.
Is the nag-1/wa580 transmission suitable for muscle car projects?
We have developed a complete wiring and computer package to run the 5.7L/6.1L/6.4L Hemi engines and the Nag-1/WA580 transmission found in the LX cars and some Jeeps. There is a common misconception that this transmission is not suitable for hotrod or muscle car projects.
How do I connect to the Transmission Control Module?
There are two connectors that attach to the unit for control C1 and C2. Access is obtained by removing the lower kick panel (has deck lid release button) and cover below the steering wheel and instrument cluster. The electronic control system consists of various components providing inputs to the transmission control module (TCM).
What does NAG1 mean on a fifth gear transmission?
Fifth gear is designed as an overdrive with a high-speed ratio. NAG1 identifies a family of transmissions and means �N�ew �A�utomatic �G�earbox, Generation 1. Various marketing names are associated with the NAG1 family of transmissions, depending on the transmission variation being used in a specific vehicle.