How should an expansion tank be installed?
The items which should be installed in sequence in the cold water line are (1) the EXPANSION TANK must be installed at least 18 inches away from the cold water inlet fitting on the water heater, (2) the PRESSURE GAUGE, and (3) the PRESSURE REDUCING VALVE, if required, see Figure 1.
What pressure should my expansion tank be set at?
between 50 and 60 PSI
The recommended water pressure is between 50 and 60 PSI. Thermal Expansion Tanks contain an air bladder which is pressurized with air, and expands and contracts to absorb the expanded water from the water heater. needed. Check the air pressure in the Expansion Tank using a tire gauge.
Should an expansion tank be vertical or horizontal?
In general, the tank can be installed vertically above or below the plumbing, or horizontally. Typically, the tank is only required to be supported when installed in the horizontal position. Most smaller tanks are designed to be supported by the plumbing, when installed in the vertical orientation.
Is 80 psi too high for water pressure?
On average, the water pressure in a home should not be more than 80 psi. When water pressure reaches over 80 psi, signs of trouble may start to occur. High water pressure can be caused by: A local water company keeping water pressure high for tall buildings and fire hydrants in the area.
Can you hang an expansion tank upside down?
Expansion tanks can be installed in any direction. Whether oriented uprightly, horizontally, or even upside down, the expansion tank will function properly without any adverse effects. Without proper support, the expansion tank could break off its mounting pipe — especially if the tank fails and fills with water.
What is expansion tank fill pressure?
Expansion tanks are pre-charged with a 40 PSI air charge. If the inlet water pressure is higher than 40 PSI,the expansion tank’s air pressure must be adjusted to match that pressure but must not be higher than 80 PSI.
Can you drain an expansion tank?
Turn off the boiler and close the water supply valve. Allow the tank to cool if necessary. Connect a hose to the purge valve on the expansion tank or place a bucket beneath the tank. Open the purge valve and allow the tank to drain completely.