What does F71 mean?
Bonnie Frerking ,”the F70 and F71 error codes on this model of washer indicates a communication problem between the user interface control board and the central control unit (main control board). These error codes can sometimes be caused by a power surge or glitch through the electrical lines.
How do I fix the error on my Whirlpool washing machine?
An LE error code on the washer’s display indicates that the motor is locked, possibly due to a heavy wash load. Large and heavy sized loads will put a strain on the motor, causing the LE code to occur. Performing a reset on the washer will normally resolve this error with a reduced load size.
How do you clear the error code on a Whirlpool top load washer?
System error code. Press START/PAUSE once to clear the code, then press START/PAUSE again to restart washer. If the code doesn’t clear, Contact Us or Schedule Service Online. Hot and cold inlet hoses have been installed incorrectly (reversed).
What does F71 mean on a boiler?
What does the F71 fault code mean on my Vaillant boiler? According to Vaillant, the F71 fault code will be displayed on your boiler’s control panel when there’s an issue with the NTC thermistor. The PCB has noticed that on firing up, there’s been no recorded temperature change.
What is the F70 code on Whirlpool washer?
The F70 error on this model washer is a central control unit (CCU) heartbeat failure. This means there is communication loss from the central control unit and the user interface. If all the wiring and connections look good and the drum on the washer rotates replace the user interface.
What does LF on a Whirlpool washer mean?
When “LF” is displayed, there could be an issue with the water flowing into the machine. Check the water inlet hoses to be sure they are not clogged or kinked. This means shutting off the water supply, and disconnecting the water inlet hoses from the washer.
How do I read a Whirlpool error code?
Error Codes in my Whirlpool Front Load Washer
| Error Code | Error |
|---|---|
| rL or F34 | Items were detected in the washer during the Clean Washer cycle. |
| Sud or Sd | There are too many suds in the washing machine. |
| F5 E2 | The door is not locking properly. |
| F7 E1 | Indicates a motor speed sensing error, |
Is there a way to reset a Whirlpool washer?
Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
How do I reset my Whirlpool Cabrio Top load washer?
Press the Start Stop button once. Rotate the dial until Rinse, Wash, and Stop light illuminate. Turn the washer off and unplug it for 10 seconds. Finally, turn on the washer and it should now be reset.