What does it mean when the airbag light is blinking?
The thin circuit bands may become worn or brittle and can cause the airbag on the driver’s seat to report a Soft-code error to the airbag control module which will make the airbag light start flashing. The reason for the wearing down of the circuit bands is due to the normal use.
How do you turn off the airbag light on a Ford Escape?
To reset the airbag light in a Ford Escape You can follow these directions listed here – Step 1 insert the key into the ignition and turn the switch to “on”. Step 2 Pay attention tot he light as it will illuminate for seven seconds and then shut off. After the shut off turn the ignition off and wait for 3 seconds.
Why is my airbag light on in my Ford f150?
If the airbag light is on in Your Ford F-150 it means that the airbag system has either deployed or detected a fault within the system. IAlways recommend You check the airbag system, or have a dealership check it.
Where is the airbag sensor located on a Ford f150?
The F-150’s airbag sensors are located under the driver and passenger seats and inside the safety belts. The location helps the airbag unit determine when someone is occupying the seat and when the belts are fastened.
What does the airbag warning light mean on a Ford airbag?
When there is a problem with a Ford’s airbag, the airbag warning light will illuminate and flash a code that identifies the problem.
What does Code 51 mean on the airbag light?
Code 51 (five flashes, pause, one flash) means the airbag diagnostic monitor’s internal fuse is blown, Code 52 (five flashes, pause, two flashes) means the back-up power supply has had a voltage boost fault and Code 53 (five flashes, pause, three flashes) means the front crash sensor has high resistance or the diagnostic monitor has failed.
What are the most common airbag problems?
Because airbag problems range from a lost battery feed to a shorted circuit, it is important to understand the codes so that the airbag can be properly repaired. These codes are started by a single flash of the indicator light, followed by a two-second pause.
What does code 13 mean on an airbag light?
Code 13 (single flash, pause, three flashes) means that the airbag circuit has shorted to ground and Code 14 (single flash, pause, four flashes) means that the primary crash sensor circuit has shorted to ground. Codes 21 to 24