What is Frame Relay configuration?

What is Frame Relay configuration?

Frame Relay is a Layer 2 WAN protocol that cand be configured on physical serial links. In addition to physical interfaces, you can also configure two types of logical interfaces for Frame Relay – point-to-point and multipoint.

How do you set up a Frame Relay?

Creating Frame Relay Topology in Cisco Packet Tracer

1. In the right pane, select the values in the following order from the drop-down lists, and then click Add.
2. Next, select Frame Relay under CONNECTIONS.
3. Next, select Serial2 interface, type 301 in the DLCI field, type R3-R1 in the Name field, and then click Add.

How do I configure my router as a Frame Relay switch?

Enable Frame Relay switching on the router using the command frame-relay switching in the global configuration mode. Go to the interface configuration mode of the Frame Relay interface where you want to configure Frame Relay switching.

How do you set a Frame Relay point to multipoint?

Lab Objectives

1. Configure R1’s Serial0/0 interface with two frame relay maps.
2. From R2 and R3 verify IP connectivity to the hub as well between the spokes.
3. Remove the previous configuration from R1’s Serial0/0 interface and create a point-to-multipoint sub-interface and configure it with the correct frame-relay maps.

What is Frame Relay point?

On Frame Relay networks, a single VC is always provisioned for a point-to-point connection. The same VC originates at a local end and then terminates at the remote end. A subnet address is usually assigned to each point-to-point connection. Therefore, only one DLCI can be configured per point-to-point subinterface.

What is Frame Relay in CCNA?

In frame relay, the routers connected to remote networks are usually the DTE devices while the frame relay switch is usually the DCE device. The frame relay switches move data frames from the host networks across the WAN network to the remote DTE devices.

What is frame relay switch?

Frame Relay switches create virtual circuits to connect remote LANs to a WAN. The Frame Relay network exists between a LAN border device, usually a router, and the carrier switch.

What is a point-to-point configuration?

The point-to-point is a kind of line configuration which describes the method to connect two communication devices in a link. The point-to-point connection is a unicast connection. There is a dedicated link between an individual pair of sender and receiver.

What is Frame Relay switch?

What does the Frame Relay interface DLCI command configure?

The frame-relay interface-dlci dlci command performs dynamic address mapping using Inverse ARP to map the next-hop protocol address to the local DLCI on the router.

What is Frame Relay Cisco?

What are the functions of Frame Relay?

Frame relay is a computer networking structure that allows for a quick and efficient way to transmit frames from one device to another. These frames, or packets of data, are usually sent between local area networks (LANs) within a wide area network (WAN).

What is the speed of a frame relay?

Frame relay complements and provides a mid-range service between ISDN , which offers bandwidth at 128 Kbps, and Asynchronous Transfer Mode (ATM), which operates in somewhat similar fashion to frame relay but at speeds of 155.520 Mbps or 622.080 Mbps.

What is a WAN Frame Relay?

Frame Relay is a widely used Wide Area Network (WAN) protocol. A layer 2 protocol, frame relay is used to create a private network through the carrier’s network.

What is Frame Relay protocol?

Frame Relay is a high-performance WAN protocol that operates at the physical and data link layers of the OSI reference model. Frame Relay originally was designed for use across Integrated Services Digital Network (ISDN) interfaces.