What is the best tool to use to cut laminate flooring?
Jigsaw + special Laminate Cutting Blades The jigsaw is the best power tool to use to cut laminate floors with for a few reasons. It’s light, important because you’ll be picking it up all day. Also, the best blades are cheap.
What can I use instead of a pull bar for laminate flooring?
An alternative to the basic pull bar is a Lam-Hammer. This simple tool consists of a handle, a hook and a slide hammer that pulls together flooring much quicker and easier than swinging a hammer near a finished wall.
How can I get my laminate floors to snap together?
It snaps together by lining up the planks at an angle and then flattening out the row being installed. To save the edges of the flooring boards, use a tapping block or rubber mallet to tap adjoining rows together. This will prevent damage to the tongue or groove with the hammer.
How can I cut laminate flooring without chipping?
How to Cut Floor Boards Without Chipping
- Mark and measure where you want to cut the boards beforehand with chalk or pencil.
- Keep your board in place using a stand or a clamp.
- Wear goggles, a mask, and gloves.
- Use a table or circular saw to make long, straight cuts. For angles, use a utility knife or a jigsaw.
What does a tapping block do?
A tapping block protects the plank from the hammer and allows you to set it gently into the groove of the adjacent plank. To use a tapping block, install the planks groove over tongue, rather than tongue over groove.
Why won’t my laminate floor click together?
Some common reasons why laminate pieces won’t snap into each other include: A warped or flawed piece of laminate. A heaved or uneven subfloor. A piece of debris trapped under the flooring or underlayment, or in the flooring’s grooves.
What holds laminate flooring in place?
rubber underlayment
Laminate flooring is supported by a thin rubber underlayment, which forms a moisture barrier and adds a cushioning layer beneath the plastic-laminate planks. It also helps deaden sound. There are a few different types of underlayment available, so be sure to use the kind recommended by the flooring manufacturer.