What port does netapp SnapMirror use?

What port does netapp SnapMirror use?

port 10566
SnapMirror and SnapVault use TCP port 10566 for data transfer. Network connections are always initiated by the destination system; that is, SnapMirror and SnapVault pull data rather than push data.

What ports does netapp use?

There are four Kerberos ports in the /etc/services file: TCP port 88, UDP port 88, TCP port 750, and UDP port 750. These ports are used only for outbound connections from your storage system . Your storage system does not run Kerberos servers or services and does not listen on these ports.

What protocol does SnapMirror use?

SnapMirror uses the typical socket/bind/listen/accept sequence on a TCP socket. SnapMirror source binds on port 10566.

What is SnapMirror?

SnapMirror is a feature of Data ONTAP that enables you to replicate data. SnapMirror enables you to replicate data from specified source volumes or qtrees to specified destination volumes or qtrees, respectively. You can use SnapMirror to replicate data within the same storage system or with different storage systems.

What is TCP port 750 used for?

There are four Kerberos ports in the /etc/services file: TCP port 88, UDP port 88, TCP port 750, and UDP port 750. These ports are used only for outbound connections from your storage system. Your storage system does not run Kerberos servers or services and does not listen on these ports.

What port does NFS use?

port 2049
NFS uses port 2049. NFSv3 and NFSv2 use the portmapper service on TCP or UDP port 111. The portmapper service is consulted to get the port numbers for services used with NFSv3 or NFSv2 protocols such as mountd, statd, and nlm.

What is DP and XDP in NetApp?

“DP” are block-based and uses BRE (Block Replication Engine) “All the rest of it”, (file-based) i.e XDP, SnapVault and version independent SnapMirror uses LRE (Logical Replication Engine) BRE (suited for disaster type of scenario) = Tracks each “block” and is unaware of file-system structure.

What ports do snapsnapmirror and ONTAP use?

SnapMirror relationships use port 11104 and port 11105 on the intercluster network to replicate data from their source volumes to their destination volumes. Clustered Data ONTAP uses port 11104 to manage intercluster communication sessions and uses port 11105 to transfer data.

What are the firewall requirements for intercluster SnapMirror with ONTAP 9?

What are the firewall requirements for intercluster SnapMirror with ONTAP 9? Open the following TCP ports on the intercluster network between all source and destination nodes for intercluster replication. Note: Clustered data ONTAP uses port 11104 to manage intercluster communication sessions; it uses port 11105 to transfer data.

What port does SnapMirror source bind on?

SnapMirror source binds on port 10566. The destination storage system contacts the SnapMirror source storage system at port 10566 using any of the available ports assigned by the system. The firewall must allow requests to this port of the SnapMirror source storage system.

What ports are required for synchronous SnapMirror?

The firewall must allow requests to this port of the SnapMirror source storage system. Synchronous SnapMirror requires additional TCP ports to be open. The source storage system listens on TCP ports 10566 and 10569.