Why are my brake lights staying on Hyundai Santa Fe?

Why are my brake lights staying on Hyundai Santa Fe?

Bad Switch: One common reason for the Parking Brake light to stay on is a failing or failed switch. This can be checked easily by jiggling the handle after it is down. If the light turns off (or turns off and then back on), the switch is the most likely culprit and will need to be replaced.

What would cause brake lights to stay on all the time?

The most likely cause for the brake lights to stay on is the brake light switch that is attached closed. You can disconnect the brake light switch plug from the brake light pedal to see if the lights turn off.

Why are my brake lights not turning off?

A common cause for car brake lights that won’t turn on is a faulty brake light switch. This component can be found beneath your dash attached near the brake pedal. If your lights are disabled, it may be sticking closed or the part has failed.

What do you do when your brake lights wont turn off?

The brake lights won’t turn off if the switch is stuck or not working properly. You might need to adjust or replace the brake switch to fix the issue. The automobile battery starts to drain if the brake lights are ON for long. The professionals suggest detaching the car battery when facing this issue.

How do you remove the brake light on a Hyundai?

Procedure

1. Open trunk.
2. Remove the cover and access the back of the tail light assembly.
3. Disconnect the electrical wire.
4. Remove the brake light socket by turning it counterclockwise.
5. Remove the brake light bulb from the socket by pulling it out.
6. Install the new brake light bulb into the socket.

How do you fix a brake light that stays on?

Here are common ways to fix brake lights that stay on:

1. Check the brake light switch for damage.
2. Replace blown fuses.
3. Install a new brake light switch.
4. Keep your brake pedal bumper functional.
5. Replace burnt-out bulbs.
6. Detach the car battery.
7. Keep your brake pedal dirt-free.
8. Ensure the brake pedal pushes the switch correctly.

What does the brake warning light mean on a Hyundai Santa Fe?

The brake warning light indicates that your Santa Fe has detected that one of its major brake components has failed, typically detected through a loss of pressure. You’ll feel a loss of pressure that manifests itself in the form of a “mushy” brake pedal.

Why do my brake lights stay on on my Hyundai?

The Hyundai vehicles listed below are subject to a recall to fix a Hyundai brake lights stay on issue caused by a defective brake light switch. The years and models affected are: This is a safety related recall. Contact the dealer if your vehicle fits the description above and make an appointment for a free brake switch replacement

Where is the brake light switch located?

It’s right on the brake pedal arm. If this plastic piece breaks off the brake lights switch will open the and keep the brake lights on. 29 people found this helpful.

What does it mean when the brake light comes on?

The brake light indicates that there is a problem with the physical braking system itself. If you are reading this article trying to figure out whether you should drive your vehicle, check the emergency brake first.