Why does my boiler says ignition lockout?
What Does Lockout Mean on a Boiler? A boiler lockout is a shut-down procedure that initiates when a boiler is not working within certain tolerances. Boilers can lock out due to low/high water pressure, lack of, or no fuel supply (gas, LPG or oil), a blockage in the system, or the lack of power to electronic components.
What does ignition failure mean on boiler?
What does ignition lockout mean on a boiler? This means that the boiler has turned itself off because of an issue, such as low water pressure, no gas supply or a lack of electricity. You’ll generally be able to decipher the problem as the boiler should show a fault code on the screen.
What does lockout mean on a Worcester boiler?
effectively shut down
Boiler lockout is a term used by boiler manufacturers to mean that the boiler has effectively shut down. When a boiler has a fault, ‘lockout’ prevents further damage.
How do you reset the pilot light on a Worcester boiler?
In the event of a fault, the blue mains indicator light will flash if there is a fault. To reset the boiler turn the Central heating temperature knob anticlockwise to the “RESET” position and hold for approximately five seconds and then turn the knob back to the original temperature setting.
How do you reset a Worcester Greenstar oil boiler?
Worcester Greenstar Ri Boiler Reset To reset the boiler turn the Central heating temperature knob anticlockwise to the “RESET” position and hold for approximately five seconds and then turn the knob back to the original temperature setting.
How do you reset a Worcester boiler?
When you need to reset your boiler, simply press and hold the reset button that can be found on the front of your boiler control panel. You need to hold the button down for 3-5 seconds to ensure that it is reset before re-checking the system to make sure it is working.
What are the common causes of burner ignition failure or flame failure?
The flame failure trip in a typical boiler can be due to one of the following reasons: loss of ignition; fuel valve closed, unstable flame, low airflow, very high furnace pressure, dirty flame sensor and loss of electrical supply.
How do you reignite a Worcester Greenstar boiler?
To reset the boiler turn the Central heating temperature knob anticlockwise to the “RESET” position and hold for approximately five seconds and then turn the knob back to the original temperature setting.
How do I reset my Worcester Greenstar 28i Junior boiler?
To reset the boiler press the reset button for approximately five seconds. When the boiler resets the reset button will no longer be illuminated. 2. The mains indicator will no longer be flashing.
How do I reset my Worcester 28i boiler?
The appliance can be reset by pressing the fault indicator button and holding in for 5 seconds when the appliance has cooled. If this condition continues to occur, then call a service engineer. The appliance will enter a lockout condition in the event of the burner failing to ignite.