Why is my agitator not spinning Maytag?
Common solutions for: Maytag Washer won’t agitate. If the washer won’t agitate, replacing the agitator repair kit may solve the problem. The kit contains the agitator components that are most likely to wear out and/or fail. If any of the parts are worn out, stripped, or damaged, replace the kit.
What causes a washer to lock up?
Reasons why your washing machine door might be stuck If the washing machine door won’t open, even when the water has been properly pumped out, it could be because of a faulty pressure switch or a blockage in the pressure system, as it could be trapping the air that’s operating the door lock.
Why won’t my washer agitate or spin?
Common solutions for: My Washer Won’t Spin or Agitate. Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it. If the washer is overloaded, the motor coupling will fail in order to protect both the motor and transmission.
How do you take the agitator out of a Maytag commercial washer?
How to Replace Your Maytag Washer’s Agitator Assembly
- Unplug the appliance.
- Lift the lid.
- Remove the fabric softener dispenser.
- Loosen the agitator.
- Remove the agitator completely.
- Put the bolt in position before putting the agitator in the machine.
- Assemble the agitator.
How do you reset the lid lock on a Maytag washer?
Once paused, the lid automatically unlocks to allow changes to the current load.
- Touch “Cycle Signal” near the front-loading washer’s LCD control panel to deactivate the washer’s lock controls.
- Push “Start/Pause” to temporarily halt the washer’s current cycle, and wait for the indicator light below “Pause” to light up.
Why is my washer not agitating or spinning?
How do I know if my washing machine agitator is bad?
When the top half of the agitator in a top-load washer doesn’t agitate as it should, or if you can turn the agitator back and forth freely, it could mean the agitator dogs are worn out.
How do I get the agitator out of my Maytag washer?
If removing the Maytag agitator from a Maytag washer, use masking tape to stick the washer lid on the top panel. Locate the retaining clips using a plastic putty knife inserted between the front panels and the top, and loosen the center bolt of the agitator before setting it aside.
What are the problems with Maytag washers?
Common problems with Maytag Bravos washers include failure to start, water filling slowly, water leakage, failure of the door or lid to lock and overflowing.
Why is my Maytag washer not agitating?
When your machine stops agitating, your clothes might end up looking less clean than you’d prefer. If your Maytag washer won’t agitate but still spins, a likely cause is a broken agitator. However, a faulty transmission, damaged wash plate (if there is no agitator), or a worn-out drive block could be to blame.
How to troubleshoot a Maytag Bravos washer?
Open the lid if the washer severally vibrates during spinning and redistribute the load.