What size is the axle nut on a Dana 70?
Dana 70 80 Rear Hub Nut Nylon Lock 2″ 16 TPI 2 9/16″ Socket Full Float Dodge, Ford, GM. This is an aftermarket rear hub nut for use on Dana 70 and 80 rear axles with 2″ 16 threads per inch.
What size socket fits the axle nut?
A Must Have for Front End Work This 36mm axle nut socket is extra deep to fit various axle lengths and can be used to remove or install axle nuts on front wheel drive vehicles.
What size is a BMW axle nut?
The axle nut is 6 point and iirc, it’s 32mm.
What size is the axle nut on a Dana 30?
35mm is the correct size. Thanks for clarifying and providing the correction information. Factory was 35mm, my RCVs are 36mm. *should be a 35mm – in my case it’s too small for the factory axle nut.
What size is a spindle nut?
-16 Hex Size 1-1/16 In.
What size are trailer axle nuts?
1″ –
This is 1″ – 14 thread standard castle nut that will work on nearly all trailer axles. This size and thread is very standard. The Castle style is used with both Cotter Pins and Tang Washers to secure your assembly effectively.
What size is the axle nut on a BMW 328i?
36MM X 12 PT
A432 – Axle Nut Socket – 36MM X 12 PT.
What size is e46 axle nut?
Registered. the rear is a 36mm 12point nut… I work at BMW and have done many wheel bearings.
What size is the axle nut on a 2012 Jeep Wrangler?
35mm is the nut size, they say 36mm will work. X2 35mm is a tight fit sometimes, but a gently tap seats the socket. A 36 mm fits a little loose, but if it’s a six sided socket it is perfectly fine.
What size is the axle nut on a 99 Jeep Cherokee?
36mm
Use a pair of Wire Cutters to pull the cotter pin for the axle nut. Then remove the nut using a 36mm socket.
How do you measure axle nut size?
Stretch the tape measure across the nut’s diameter to the flat-side directly across from the one your pulling from. If the nut is metric, count the number of lines on the tape measure to find the measurement. If you count 9 lines, the size is a 9-mm (millimeter) nut.
What size are trailer lug nuts?
There are common lug nut sizes found on trailers: 7/16, 1/2, 9/16, and 5/8 but the most common is 1/2 inch.