How do you turn off the SRS light on a Honda Civic?

How do you turn off the SRS light on a Honda Civic?

Reset Your SRS Light

1. There is a yellow plug under the dash plugged into the fuse panel.
2. Turn the ignition key to the “ON” (II) position.
3. When the SRS light comes back on plug the jumper wire back in within 4 seconds the light will blink twice and go out.
4. Unplug the jumper and turn the ignition key off.

What causes an SRS light to come on?

The most common cause for the airbag light coming on is that the airbag system is deactivated or turned off. There may be an issue with a crash sensor, SRS module, or other airbag component. Alternatively, the sensor in the passenger seat that determines whether that airbag should be active or not may be faulty.

How much does it cost to fix SRS light on Honda Civic?

What is typical cost to resolve an illuminated Supplemental Restraint System (SRS) Warning Light? Expect to pay between $100 to $200 for the initial diagnostic.

How much does it cost to fix the SRS light?

How do you make a resistor stop airbag light?

You just need to put the resistor across the circuit, that’s it. There’s two established ways of doing this when you’ve located the airbag feed, either solder it into the wires, or simply push it into the plug and tape it up.

What does the SRS light mean on a Honda Civic?

The SRS light is there to tell you when something is wrong with your airbags, but sometimes it’ll stay on for no reason. Here’s how you reset it. This article applies to the Honda Civic (1992-2000). The SRS (Supplement Restraint System) warns you if something is wrong with the air bag system.

What does the airbag light mean on a Honda Civic?

This article applies to the Honda Civic (1992-2000). The SRS (Supplement Restraint System) warns you if something is wrong with the air bag system. Sometimes the light comes on when there’s nothing wrong with the system at all. Performing a quick reset should shut off the light.

How to reset the SRS light on a Honda Honda?

Honda: How to Reset the SRS Light 1 Locate the MES. Locate the MES (Memory Erase Signal) connector. 2 Short the MES. In this step, you will internally make the connection in the plug to “short” it. 3 Cycle the ignition. With this connection made, turn the ignition key to the “on” position (do not start the engine).

How do I know if the SRS reset is working?

You’ll know it worked when the SRS light blinks twice. If the reset didn’t work, it means that the SRS is getting an error. This can be caused by the steering wheel, airbags, gauges, or seats being disconnected when the ignition comes on. It could also be a bad SRS module.