What year Explorer has 31 spline axles?
1995
Part # A31-95EXPL – 1995-Newer Explorer C-Clip Axles – 31 Spline.
Which Ford Explorers have the 8.8 rear end?
Explorer Addict You can get a 8.8 with disks off of any 95 or later Explorer. All of these have 31 splines. I don’t know how much a junk yard would want but someone on this board has one for sale with 3.73s from a 99 Explorer for $500.
What is the point of a solid axle swap?
With a solid axle swap, prepare to rip everything out of the truck pertaining to steering, suspension, and the axle. Depending on the application, cutting off mounting points on the frame may be required as well. And even with a direct swap kit, welding will be necessary for mounting the springs and suspension system.
How do I know if my Ford 8.8 is a limited slip?
Look at the axle code in the driver’s door sill or on the tag that’s mounted to the diff cover. It should have an “L” in the code if your rear axle is limited slip. another way to check is jack up the rear end of the truck so both wheels are off the ground and put the trans in neutral.
Do all Explorers have 31-spline axles?
All Explorer’s are equipped with a 31-spline 8.8-Inch axle.
What year did Ford Explorer switch to independent rear suspension?
For 2002-2004, Ford’s AdvanceTrac with Roll Stability Control system was an option, this became standard for the 2005 year model. Ford gave the 4-door version a fully independent rear suspension, but not the 2-door models. This setup replaced the live axle rear suspension used in previous years.
Is Ford 8.8 limited slip?
Like other Ford axles, the 8.8-inch came in both 28-spline and 31-spline versions. Aftermarket lockers are available to adapt the 8.8-inch open rear to limited-slip. If you find one with the correct axle width, you can build it to your own specifications easily.
What is better posi or limited slip?
The limited-slip differential is similar to the positraction differential, but allows the wheel with traction to have only a limited amount of greater power than the wheel that is slipping. A limited-slip differential will prevent the tire with less traction from separately spinning.
What year did the Ford Explorer have an 8 8 axle?
Ford Explorer: The 8.8-Inch axle came in Ford Explorers (and Mazda Navajo) in 1990 as a 1991 model year. The Ford Explorer used it until it switched to an independent rear suspension in 2002.
What kind of axle does a Ford Explorer FX4 have?
The 2003-up FX4 (non-Level II) is essentially the same as the 1998-2002 Off-Road except that a regular Ford limited-slip in a regular 8.8-inch was included. Ford Explorer: The 8.8-Inch axle came in Ford Explorers (and Mazda Navajo) in 1990 as a 1991 model year. The Ford Explorer used it until it switched to an independent rear suspension in 2002.
What’s the difference between the Ford Ranger and Ford Explorer axle tubes?
The Ford Ranger 28-spline 8.8-Inch axle tube is 2.80 inches in diameter. The Ford Ranger 31-spline 8.8-Inch axle tube is 3.25 inches in diameter. The Ford Explorer 31-spline 8.8-Inch axle tube is 3.25 inches in diameter.
What is the Ford Explorer 31 spline axle size?
The Ford Explorer 31-spline 8.8-Inch axle tube is 3.25 inches in diameter. Increasing from a 28-spline to a 31-spline axle allegedly increases strength of the axle shaft by 34%, however I’ll go by the capacity ratings of the axle assemblies provided by the manufacturer.